ISATAP Extensions for Mobility, Multihoming and Efficiency Improvement (IEMMEI)
draft-templin-v6ops-iemmei-01
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Fred Templin | ||
| Last updated | 2004-05-10 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The Intra-Site Automatic Tunnel Addressing Protocol (ISATAP) connects IPv6 hosts/routers over IPv4 networks via automatic tunneling using a link abstraction similar to the Non-Broadcast, Multiple Access (NBMA) model. This document describes operational extensions for ISATAP that enable a dynamic tunnel endpoint management abstraction similar to the ATM Permanent/Switched Virtual Circuit model. Nodes can use these extensions to realize mobility, multihoming and efficiency improvements.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)