LIN6: A Solution to Multihoming and Mobility in IPv6

Document Type Expired Internet-Draft (individual)
Author Fumio Teraoka 
Last updated 2004-01-09
Stream (None)
Intended RFC status (None)
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


LIN6 is a protocol supporting multihoming and mobility in IPv6. LIN6 introduces the node id, not the interface id, for each node. Each node can be identified by its node id no matter where the node is connected and no matter how many interfaces the node has. In the IPv6 layer, 64-bit node id called LIN6 ID is used while 128-bit node-id called LIN6 generalized ID is used above the Transport layer. TCP connections and security associations can be preserved even if the node moves to another subnet or the node changes the using interface in a multihoming environment without modifying TCP or IPsec. In comparison with Mobile IPv6, LIN6 has several advantages in terms of header overhead and fault tolerance.


Fumio Teraoka (

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)