MPL Forwarder Select (MPLFS)
draft-vanderstok-roll-mpl-forw-select-01
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Peter Van der Stok , Abdur Rashid Sangi | ||
| Last updated | 2016-10-14 | ||
| Replaced by | draft-ietf-roll-mpl-forw-select | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-roll-mpl-forw-select | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes a Forwarder Selection (MPLFS) protocol for the Multicast Protocol for Low-Power and lossy Networks (MPL) to reduce the density of forwarders such that the number of forwarded messages is reduced. The protocol uses Trickle to distribute link- local information about the identity of the neighbours of the nodes that have MPL-enabled interfaces. In the end-state all nodes are connected to a minimum number, N_DUPLICATE, of forwarders, where N_DUPLICATE is application dependent, and there is a path between any two forwarders.
Authors
Peter Van der Stok
Abdur Rashid Sangi
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)