Skip to main content

Multipath Extensions for MPLS Traffic Engineering
draft-villamizar-mpls-multipath-extn-00

Document Type Expired Internet-Draft (individual)
Author Curtis Villamizar
Last updated 2013-05-17 (Latest revision 2012-11-13)
Replaces draft-villamizar-mpls-tp-multipath-te-extn
Stream (None)
Formats
Expired & archived
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

Extensions to OSPF-TE, ISIS-TE, and RSVP-TE are defined in support of carrying LSP with strict packet ordering requirements over multipath and and carrying LSP with strict packet ordering requirements within LSP without violating requirements to maintain packet ordering. LSP with strict packet ordering requirements include MPLS-TP LSP. OSPF-TE and ISIS-TE extensions defined here indicate node and link capability regarding support for ordered aggregates of traffic, multipath traffic distribution, and abilities to support multipath load distribution differently per LSP. RSVP-TE extensions either identifies an LSP as requiring strict packet order, or identifies an LSP as carrying one or more LSP that requires strict packet order further down in the label stack, or identifies an LSP as having no restrictions on packet ordering except the restriction to avoid reordering microflows. In addition an extension indicates whether the first nibble of payload will reliably indicate whether payload is IPv4, IPv6, or other type of payload, most notably pseudowire using a pseudowire control word.

Authors

Curtis Villamizar

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)