Skip to main content

PIM Join Attributes for Locator/ID Separation Protocol (LISP) Environments
draft-vs-pim-rfc8059-9798bis-00

Document Type Replaced Internet-Draft (individual)
Expired & archived
Authors Vengada Prasad Govindan , Stig Venaas
Last updated 2025-12-30 (Latest revision 2025-06-28)
Replaced by draft-ietf-pim-rfc8059-9798bis
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-pim-rfc8059-9798bis
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document defines two PIM Join/Prune attributes that support the construction of multicast distribution trees where the root and receivers are located in different Locator/ID Separation Protocol (LISP) sites. These attributes allow the receiver site to select between unicast and multicast underlying transport, to convey the RLOC (Routing Locator) address of the receiver ETR (Egress Tunnel Router) to the control plane of the root ITR (Ingress Tunnel Router) and to signal the underlay multicast group to the control plane of the root ITR. This document updates RFC 8059 and RFC 9798.

Authors

Vengada Prasad Govindan
Stig Venaas

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)