Port Identifier option for RS/RA messages in IPv6 access network
draft-wen-ipv6-rsra-opt-pid-01
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Haibo Wen | ||
Last updated | 2006-06-23 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document makes an extension to stateless address auto- configuration (SAAC) mechanism by defining Port Identifier option for RS/RA messages in IPv6 access network. This option can make SAAC possible without upgrading access node and CPE to be layer 3 devices.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)