How to Write an RTP Payload Format
draft-westerlund-avt-rtp-howto-00
This document is an Internet-Draft (I-D).
Anyone may submit an I-D to the IETF.
This I-D is not endorsed by the IETF and has no formal standing in the
IETF standards process.
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Magnus Westerlund | ||
| Last updated | 2006-05-08 (Latest revision 2006-02-27) | ||
| Replaced by | draft-ietf-avt-rtp-howto | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-avt-rtp-howto | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document contains information on how to best write an RTP payload format. Reading tips, design practices, and practical tips on how to quickly and with good results produce an RTP payload format specification. A template is also included with instructions that can be used when writing an RTP payload format.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)