Sub-interface VLAN YANG Data Models
draft-wilton-netmod-intf-vlan-yang-03

The information below is for an old version of the document
Document Type Active Internet-Draft (individual)
Last updated 2016-07-08
Replaces draft-netmod-wilton-intf-vlan-yang, draft-wilton-intf-vlan-yang
Replaced by draft-ietf-netmod-sub-intf-vlan-model
Stream (None)
Intended RFC status (None)
Formats pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state I-D Exists
Telechat date
Responsible AD (None)
Send notices to (None)
Internet Engineering Task Force                           R. Wilton, Ed.
Internet-Draft                                                   D. Ball
Intended status: Standards Track                                T. Singh
Expires: January 9, 2017                                   Cisco Systems
                                                              S. Sivaraj
                                                        Juniper Networks
                                                            July 8, 2016

                  Sub-interface VLAN YANG Data Models
                 draft-wilton-netmod-intf-vlan-yang-03

Abstract

   This document defines YANG modules to add support for classifying
   traffic received on interfaces as Ethernet/VLAN framed packets to
   sub-interfaces based on the fields available in the Ethernet/VLAN
   frame headers.  These modules allow IETF forwarding protocols (such
   as IPv6 and VPLS) to interoperate with VLAN tagged traffic orginated
   from an IEEE 802.1Q compliant bridge.  Primarily the classification
   is based on VLAN identifiers in the 802.1Q VLAN tags, but the model
   also has support for matching on some other layer 2 frame header
   fields and is designed to be extensible to match on other arbitrary
   header fields.

   The model differs from an IEEE 802.1Q bridge model in that the
   configuration is interface/sub-interface based as opposed to being
   based on membership of an 802.1Q VLAN bridge.

Status of This Memo

   This Internet-Draft is submitted in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF).  Note that other groups may also distribute
   working documents as Internet-Drafts.  The list of current Internet-
   Drafts is at http://datatracker.ietf.org/drafts/current/.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   This Internet-Draft will expire on January 9, 2017.

Wilton, et al.           Expires January 9, 2017                [Page 1]
Internet-Draft           Sub-interface VLAN YANG               July 2016

Copyright Notice

   Copyright (c) 2016 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (http://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . .   3
     1.1.  Terminology . . . . . . . . . . . . . . . . . . . . . . .   3
     1.2.  Tree Diagrams . . . . . . . . . . . . . . . . . . . . . .   4
   2.  Objectives  . . . . . . . . . . . . . . . . . . . . . . . . .   4
     2.1.  Interoperability with IEEE 802.1Q compliant bridges . . .   4
     2.2.  Extensibility . . . . . . . . . . . . . . . . . . . . . .   4
   3.  L3 Interface VLAN Model . . . . . . . . . . . . . . . . . . .   5
   4.  Flexible Encapsulation Model  . . . . . . . . . . . . . . . .   5
   5.  L3 Interface VLAN YANG Module . . . . . . . . . . . . . . . .   7
   6.  Flexible Encapsulation YANG Module  . . . . . . . . . . . . .  10
   7.  802.1Q Types YANG Module  . . . . . . . . . . . . . . . . . .  19
   8.  Acknowledgements  . . . . . . . . . . . . . . . . . . . . . .  24
   9.  ChangeLog . . . . . . . . . . . . . . . . . . . . . . . . . .  24
     9.1.  Version -03 . . . . . . . . . . . . . . . . . . . . . . .  24
   10. IANA Considerations . . . . . . . . . . . . . . . . . . . . .  25
   11. Security Considerations . . . . . . . . . . . . . . . . . . .  25
     11.1.  if-l3-vlan.yang  . . . . . . . . . . . . . . . . . . . .  25
     11.2.  flexible-encapsulation.yang  . . . . . . . . . . . . . .  26
   12. References  . . . . . . . . . . . . . . . . . . . . . . . . .  27
     12.1.  Normative References . . . . . . . . . . . . . . . . . .  27
     12.2.  Informative References . . . . . . . . . . . . . . . . .  28
   Appendix A.  Comparison with the IEEE 802.1Q Configuration Model   29
     A.1.  Sub-interface based configuration model overview  . . . .  29
     A.2.  IEEE 802.1Q Bridge Configuration Model Overview . . . . .  30
     A.3.  Possible Overlap Between the Two Models . . . . . . . . .  30
   Authors' Addresses  . . . . . . . . . . . . . . . . . . . . . . .  31

Wilton, et al.           Expires January 9, 2017                [Page 2]
Show full document text