IPv6-only and Dual Stack Hosts on the Same Network with DNS64
draft-wing-behave-dns64-config-03
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Dan Wing | ||
| Last updated | 2011-02-14 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Some networks are expected to support IPv4-only, dual-stack, and IPv6-only hosts at the same time. Such networks also want to IPv6/ IPv4 translation for the IPv6-only host so it can access servers on the IPv4 Internet. On such a network, the synthesized AAAA responses from a DNS64 can cause traffic to be translated. This document describes a solution to avoid that translation when the application uses DNS.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)