Factory default Setting
draft-wu-netconf-restconf-factory-restore-03
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Qin Wu , Balázs Lengyel , Ye Niu | ||
| Last updated | 2019-04-14 (Latest revision 2018-10-11) | ||
| RFC stream | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document defines a method to reset a YANG datastore to its factory-default content. The reset operation may be used e.g. during initial zero-touch configuration or when the existing configuration has major errors, so re-starting the configuration process from scratch is the best option. A new reset-datastore RPC is defined. Several methods of documenting the factory-default content are specified. Optionally a new "factory-default" read-only datastore is defined, that contains the data that will be copied over to the running datastore at reset.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)