Skip to main content

Factory default Setting
draft-wu-netmod-factory-default-03

Document Type Replaced Internet-Draft (individual)
Expired & archived
Authors Qin Wu , Balázs Lengyel , Ye Niu
Last updated 2019-05-06
Replaced by draft-ietf-netmod-factory-default
RFC stream (None)
Intended RFC status (None)
Formats
Yang Validation 0 errors, 2 warnings
Additional resources Yang catalog entry for ietf-factory-default@2019-05-03.yang
Yang impact analysis for draft-wu-netmod-factory-default
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-netmod-factory-default
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document defines a method to reset a YANG server to its factory- default content. The reset operation may be used e.g. during initial zero-touch configuration or when the existing configuration has major errors, so re-starting the configuration process from scratch is the best option. A new factory-reset RPC is defined. Several methods of documenting the factory-default content are specified. Optionally a new "factory-default" read-only datastore is defined, that contains the data that will be copied over to the running datastore at reset.

Authors

Qin Wu
Balázs Lengyel
Ye Niu

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)