Throughput Measurement for MPLS-based Transport Networks
draft-xhk-mpls-tp-throughput-03
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Feng Huang , Han Li , Xiao Min , Ruiquan Jing , Sriganesh Kini | ||
Last updated | 2012-04-13 (Latest revision 2011-10-11) | ||
Replaces | draft-flh-mpls-tp-oam-diagnostic-test, draft-xiao-mpls-tp-throughput-estimation | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
An important Operation, Administration and Maintenance (OAM) requirement of the MPLS Transport Profile (MPLS-TP) is the ability to measure the throughput (i.e. bandwidth) of an MPLS-TP connection which could be an MPLS-TP PseudoWire (PW), Label Switched Path (LSP) or Section. This document specifies the OAM packet formats and procedures for both one-way and two-way throughput measurement in MPLS-TP.
Authors
Feng Huang
Han Li
Xiao Min
Ruiquan Jing
Sriganesh Kini
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)