LSP Object Flag Extension of Stateful PCE
draft-xiong-pce-lsp-flag-02
Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
Expired & archived
|
|
---|---|---|---|
Author | Quan Xiong | ||
Last updated | 2020-12-02 (Latest revision 2020-05-31) | ||
Replaced by | draft-ietf-pce-lsp-extended-flags, draft-ietf-pce-lsp-extended-flags, draft-ietf-pce-lsp-extended-flags, RFC 9357 | ||
RFC stream | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
RFC8231 describes a set of extensions to PCEP to enable stateful control of MPLS-TE and GMPLS Label Switched Paths(LSPs) via PCEP. One of the extensions is the LSP object which includes a Flag field and the length is 12 bits. However, 11 bits of the Flag field has been assigned in RFC8231, RFC8281 and RFC8623 respectively. This document proposes to define a new LSP-EXTENDED-FLAG TLV for LSP object to extend the length of the flags.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)