Encapsulating MPLS in UDP
draft-xu-mpls-in-udp-06

Document Type Replaced Internet-Draft (individual)
Last updated 2013-02-21 (latest revision 2012-12-10)
Replaced by draft-ietf-mpls-in-udp
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
plain text pdf html bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-mpls-in-udp
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-xu-mpls-in-udp-06.txt

Abstract

Existing technologies to encapsulate Multi-Protocol Label Switching (MPLS) over IP are not adequate for efficient load balancing of MPLS application traffic, such as MPLS-based Layer2 Virtual Private Network (L2VPN) or Layer3 Virtual Private Network (L3VPN) traffic across IP networks. This document specifies additional IP-based encapsulation technology, referred to as MPLS-in-User Datagram Protocol (UDP), which can facilitate the load balancing of MPLS application traffic across IP networks.

Authors

Xiaohu Xu (xuxiaohu@huawei.com)
Nischal Sheth (nsheth@contrailsystems.com)
Lucy Yong (lucy.yong@huawei.com)
Carlos Pignataro (cpignata@cisco.com)
Fan Yongbing (fanyb@gsta.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)