One-way delay measurement method based on Digital Twin Network
draft-yc-nmrg-dtn-owd-measurement-01
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Hongwei Yang , Danyang Chen | ||
| Last updated | 2023-04-24 (Latest revision 2022-10-21) | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document implements an accurate network delay measurement method based on the digital twin network. This is a use case of digital twin network. This method does not need to send measurement packets, does not need to change the physical network configuration, does not need to change the format of service packets, do not require physical network elements to support the time synchronization protocol, and support the one-way delay measurement of any service packet.The digital twin network architecture of this document follows the NMRG working group paper draft-irtf-nmrg-network-digital-twin-arch-00.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)