Skip to main content

RSVP-TE Extensions for Bit Error Rate (BER) Measurement
draft-zhang-ccamp-rsvpte-ber-measure-02

Document Type Expired Internet-Draft (individual)
Authors Zhenbin Li , Li Zhang , Guangming Yang
Last updated 2015-01-04 (Latest revision 2014-07-03)
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

In the mobile backhaul network, the mobile service is sensitive to Bit Error Rate (BER). When the BER value of the service exceeds the threshold, the cell site equipments will stop working and the mobile terminal users cannot obtain voice and data services anymore. Now the mobile backhaul tends to be IP/MPLS network and MPLS TE LSP is used to bear the mobile service which may be encapsulated in PW or L3VPN end to end. Then the ingress Label Switched Router (LSR) of the MPLS TE LSP needs to get information on BER along the path of the LSP. This document proposes new extensions of RSVP-TE to advertise the BER measurement requirement of the specific LSP to all of the transit LSRs and the egress LSR, and to report the BER measurement result from any transit or egress LSR towards the ingress LSR.

Authors

Zhenbin Li
Li Zhang
Guangming Yang

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)