Attribute-Value Pairs For Provisioning Customer Equipment Supporting IPv4-Over-IPv6 Transitional Solutions
draft-zhou-dime-4over6-provisioning-05
| Document | Type |
Expired Internet-Draft
(candidate for dime WG)
Expired & archived
|
|
|---|---|---|---|
| Authors | Cathy Zhou , Tom Taylor , Qiong Sun , Mohamed Boucadair | ||
| Last updated | 2015-10-14 (Latest revision 2014-09-23) | ||
| RFC stream | Internet Engineering Task Force (IETF) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Additional resources | Mailing list discussion | ||
| Stream | WG state | Call For Adoption By WG Issued | |
| Document shepherd | (None) | ||
| IESG | IESG state | Expired | |
| Consensus boilerplate | Unknown | ||
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
During the transition from IPv4 to IPv6, customer equipment may have to support one of the various transition methods that have been defined for carrying IPv4 packets over IPv6. This document enumerates the information that needs to be provisioned on a customer edge router to support a list of transition techniques based on tunneling IPv4 in IPv6, with a view to defining reusable components for a reasonable transition path between these techniques. To the extent that the provisioning is done dynamically, AAA support is needed to provide the information to the network server responsible for passing the information to the customer equipment. This document specifies Diameter (RFC 6733) attribute-value pairs to be used for that purpose.
Authors
Cathy Zhou
Tom Taylor
Qiong Sun
Mohamed Boucadair
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)