TOC 
DHCB. Volz
Internet-DraftCisco Systems, Inc.
Intended status: Standards TrackAugust 3, 2009
Expires: February 4, 2010 


DHCPv6 Vendor-specific Message

Status of this Memo

This Internet-Draft is submitted to IETF in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF), its areas, and its working groups. Note that other groups may also distribute working documents as Internet-Drafts.

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as “work in progress.”

The list of current Internet-Drafts can be accessed at http://www.ietf.org/ietf/1id-abstracts.txt.

The list of Internet-Draft Shadow Directories can be accessed at http://www.ietf.org/shadow.html.

This Internet-Draft will expire on February 4, 2010.

Copyright Notice

Copyright (c) 2009 IETF Trust and the persons identified as the document authors. All rights reserved.

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents in effect on the date of publication of this document (http://trustee.ietf.org/license-info). Please review these documents carefully, as they describe your rights and restrictions with respect to this document.

Abstract

This document requests a vendor-specific DHCPv6 message assignment. This message can be used for vendor specific and experimental purposes.



Table of Contents

1.  Introduction
2.  Terminology
3.  Vendor-specific Message
4.  Security Considerations
5.  IANA Considerations
6.  References
    6.1.  Normative References
    6.2.  Informative References
§  Author's Address




 TOC 

1.  Introduction

DHCPv6 [RFC3315] (Droms, R., Bound, J., Volz, B., Lemon, T., Perkins, C., and M. Carney, “Dynamic Host Configuration Protocol for IPv6 (DHCPv6),” July 2003.) specifies a mechanism for the assignment of addresses and configuration information to nodes. The protocol provides for 256 possible message codes, of which a small number are assigned ([DHCPv6Params] (IANA, “Dynamic Host Configuration Protocol for IPv6 (DHCPv6). http://www.iana.org/assignments/dhcpv6-parameters,” .)). Each of the assigned message codes have specific purposes. New message codes are assigned through Standards Action (see Section 24 of [RFC3315] (Droms, R., Bound, J., Volz, B., Lemon, T., Perkins, C., and M. Carney, “Dynamic Host Configuration Protocol for IPv6 (DHCPv6),” July 2003.)).

There may be a need for vendors of DHCPv6 clients, relay agents, or servers to experiment with new capabilities that require new messages to be exchanged between these elements. Thus, this document defines the format for and requests that a new message code be reserved for vendor-specific and experimental purposes.



 TOC 

2.  Terminology

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in [RFC2119] (Bradner, S., “Key words for use in RFCs to Indicate Requirement Levels,” March 1997.).



 TOC 

3.  Vendor-specific Message

The vendor-specific message may be exchanged between clients, relay agents, and/or servers and allows multiple vendors to make use of the message for completely different and independent purposes.

Clients and servers MAY chose to support this message; those that do not, MUST discard the message. Relay agents SHOULD relay these messages as they would other DHCPv6 messages unless the relay agent understands the specific message and knows that the message was directed at it.

Applications using these messages MUST NOT assume that all DHCPv6 clients, relay agents, and servers support them and MUST use good networking practices when transmitting and retransmitting these messages (see Section 14 of [RFC3315] (Droms, R., Bound, J., Volz, B., Lemon, T., Perkins, C., and M. Carney, “Dynamic Host Configuration Protocol for IPv6 (DHCPv6),” July 2003.) for recommendations). For some applications, it may be appropriate to use a Vendor Class or Vendor-specific Information Option ([RFC3315] (Droms, R., Bound, J., Volz, B., Lemon, T., Perkins, C., and M. Carney, “Dynamic Host Configuration Protocol for IPv6 (DHCPv6),” July 2003.)) in a standard DHCPv6 exchange to negotiate whether the end-points support the vendor-specific message.

The format of the DHCPv6 Vendor-specific Message is shown below:

    0                   1                   2                   3
    0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
   |    msg-type   |               enterprise-number               |
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
   |  enterprise-  |     vendor    |                               |
   | number (contd)|    msg-type   |                               .
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+                               .
   .                            options                            .
   .                       (variable length)                       .
   |                                                               |
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+

   msg-type             VENDOR-SPECIFIC (TBD)

   enterprise-number    The vendor's registered Enterprise Number as
                        registered with [EID].

   vendor-msg-type      The vendor's message-type. The values are
                        defined by the vendor identified in the
                        enterprise-number field and are not managed
                        by IANA.

   options              The vendor specific options carried in this
                        message.

The options MUST be encoded as a sequence of code/length/value fields of identical format to the DHCPv6 options field. The option codes are defined by the vendor identified in the enterprise-number field and are not managed by IANA. Each of the options is formatted as follows:

    0                   1                   2                   3
    0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
   |          opt-code             |             option-len        |
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
   .                                                               .
   .                          option-data                          .
   .                                                               .
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+

   opt-code             The code for the option.

   option-len           An unsigned integer giving the length of the
                        option-data field in this option in octets.

   option-data          The data area for the option.


 TOC 

4.  Security Considerations

The Security Considerations of [RFC3315] (Droms, R., Bound, J., Volz, B., Lemon, T., Perkins, C., and M. Carney, “Dynamic Host Configuration Protocol for IPv6 (DHCPv6),” July 2003.) apply.

This new message does potentially open up new avenues of attacking clients, relay agents, or servers. The exact nature of these attacks will depend on what functions and capabilities the message exposes and are thus not possible to describe in this document. Clients and servers that have no use for these messages SHOULD discard them and thus the threat is no different than before this message was assigned.

Vendors using this new message should use the DHCPv6 security mechanisms (the Auth option or IPsec [RFC3315] (Droms, R., Bound, J., Volz, B., Lemon, T., Perkins, C., and M. Carney, “Dynamic Host Configuration Protocol for IPv6 (DHCPv6),” July 2003.) as appropriate) and carefully consider the security implications of the functions and capabilities exposed.



 TOC 

5.  IANA Considerations

IANA is requested to assign DHCPv6 Message type 254 to the Vendor-specific Message in the registry maintained in [DHCPv6Params] (IANA, “Dynamic Host Configuration Protocol for IPv6 (DHCPv6). http://www.iana.org/assignments/dhcpv6-parameters,” .):

254 VENDOR-SPECIFIC



 TOC 

6.  References



 TOC 

6.1. Normative References

[RFC2119] Bradner, S., “Key words for use in RFCs to Indicate Requirement Levels,” BCP 14, RFC 2119, March 1997 (TXT, HTML, XML).
[RFC3315] Droms, R., Bound, J., Volz, B., Lemon, T., Perkins, C., and M. Carney, “Dynamic Host Configuration Protocol for IPv6 (DHCPv6),” RFC 3315, July 2003 (TXT).
[EID] IANA, “Private Enterprise Numbers. http://www.iana.org/assignments/enterprise-numbers.”


 TOC 

6.2. Informative References

[DHCPv6Params] IANA, “Dynamic Host Configuration Protocol for IPv6 (DHCPv6). http://www.iana.org/assignments/dhcpv6-parameters.”


 TOC 

Author's Address

  Bernard Volz
  Cisco Systems, Inc.
  1414 Massachusetts Ave.
  Boxborough, MA 01719
  USA
Phone:  +1 978 936 0000
Email:  volz@cisco.com