DNSEXT Working Group Olafur Gudmundsson (NAI Labs)
INTERNET-DRAFT January 2001
<draft-ietf-dnsext-message-size-02.txt>
Updates: RFC 2535, RFC 2874
DNSSEC and IPv6 A6 aware server/resolver message size requirements
Status of this Memo
This document is an Internet-Draft and is in full conformance with
all provisions of Section 10 of RFC2026.
Internet-Drafts are working documents of the Internet Engineering
Task Force (IETF), its areas, and its working groups. Note that
other groups may also distribute working documents as Internet-
Drafts.
Internet-Drafts are draft documents valid for a maximum of six months
and may be updated, replaced, or obsoleted by other documents at any
time. It is inappropriate to use Internet-Drafts as reference
material or to cite them other than as ``work in progress.''
The list of current Internet-Drafts can be accessed at
http://www.ietf.org/ietf/1id-abstracts.txt
The list of Internet-Draft Shadow Directories can be accessed at
http://www.ietf.org/shadow.html
Comments should be sent to the authors or the DNSEXT WG mailing list
namedroppers@ops.ietf.org
This draft expires on July 20, 2001.
Copyright Notice
Copyright (C) The Internet Society (2001). All rights reserved.
Abstract
This document mandates support for EDNS0 in DNS entities claiming to
support DNS Security Extensions and A6 records. This requirement is
necessary because these new features increase the size of DNS
messages. If EDNS0 is not supported fall back to TCP will happen,
having a detrimental impact on query latency and DNS server load.
Expires July 2001 [Page 1]
INTERNET-DRAFT DNSSEC and IPng message size requirement January 2001
1 - Introduction
Familiarity with the DNS[RFC1034, RFC1035], DNS Security
Extensions[RFC2535], EDNS0[RFC2671] and A6[RFC2874] is helpful.
RFC 1035[RFC1035] Section 2.3.4 requires that DNS messages over UDP
have a data payload of 512 octets or less. Most DNS software today
will not accept larger UDP datagram. Any answer that requires more
than 512 octets, results in a partial and sometimes useless reply
with the Truncation Bit set; in most cases the requester will then
retry using TCP. Some DNS servers send back an answer truncating the
message at the last RR boundary before truncation, other truncate at
the previous set, some send back empty answer with TC bit set.
Compared to UDP, TCP is an expensive protocol to use for a simple
transaction like DNS: a TCP connection requires 5 packets for setup
and tear down, excluding data packets, thus requiring at least 3
round trips on top of the one for the original UDP query. The DNS
server also needs to keep a state of the connection during this
transaction. Many DNS servers answer thousands of queries per second,
requiring them to use TCP will cause significant overhead and delays.
1.1 - DNSSEC motivations
DNSSEC[RFC2535] secures DNS by adding a Public Key signature on each
RR set. These signatures range in size from about 80 octets to 800
octets, most are going to be in the range of 80 to 200 octets. The
addition of signatures on each or most RR sets in an answer
significantly increases the size of DNS answers from secure zones.
For performance reasons and to reduce load on DNS servers, it is
important that security aware servers and resolvers get all the data
in Answer and Authority section in one query without truncation.
Sending Additional Data in the same query is helpful when the server
is authorative for the data, and this reduces round trips.
TSIG[RFC2845] allows for the light weight authentication of DNS
messages, but increases the size of the messages by at least 70
octets. DNSSEC specifies for computationally expensive message
authentication SIG(0) using a standard public key signature. As only
one TSIG or SIG(0) can be attached to each DNS answer the size
increase of message authentication is not significant, but may still
lead to a truncation.
DNSSEC OK[OK] specifies how a client can, using EDNS0, indicate that
it is interested in receiving DNSSEC records. The OK bit does not
eliminate the need for large answers for DNSSEC capable clients.
Expires July 2001 [Page 2]
INTERNET-DRAFT DNSSEC and IPng message size requirement January 2001
1.2 - IPv6 Motivations
IPv6 addresses[RFC2874] are 128 bits and are represented in the DNS
by multiple A6 records, each consisting of a domain name and a bit
field. The domain name refers to an address prefix that may require
additional A6 RRs to be included in the answer. Answers where
queried name has multiple A6 addresses may overflow a 512-octet UDP
packet size.
1.3 Root server and TLD server motivations
The current number of root servers is limited to 13 as that is the
maximum number of name servers and their address records that fit in
one 512-octet answer for a SOA record. If root servers start
advertising A6 or KEY records then the answer for the root NS records
will not fit in a single 512-octet DNS message, resulting in a large
number of TCP query connections to the root servers.
For redundancy, latency and load balancing reasons it is important
large number of DNS servers are used for Root and large TLD's.
1.4 UDP vs TCP for DNS messages
Given all these factors, it is essential that any implementations
that supports DNSSEC and or A6 be able to use larger DNS messages
than 512 octets.
The original 512 restriction was put in place to avoid fragmentation
of DNS responses. A fragmented UDP message that suffers a loss off
one of the fragments renders the answer useless and query must be
retried. TCP connection requires number of round trips for
establishment, data transfer and tear down, but only the lost data
segments are retransmitted.
In the early days number of IP implementations did not handle
fragmentation well, but all modern operating systems have overcome
that issue thus sending fragmented messages is fine from that
standpoint. The open issue is the effect of losses on fragmented
messages. If connection has high loss ratio only TCP will allow
reliable transfer of DNS data, most links have low loss ratios thus
sending fragmented UDP packet in one round trip is better than
establishing a TCP connection to transfer few thousand octets.
Expires July 2001 [Page 3]
INTERNET-DRAFT DNSSEC and IPng message size requirement January 2001
1.5 EDNS0 and large UDP messages
EDNS0[RFC2671] allows clients to declare the maximum size of UDP
message they are willing to handle. Thus, if the expected answer is
between 512 octets and the maximum size that the client can accept,
the additional overhead of a TCP connection can be avoided.
1.6 - Requirements
The key words ``MUST'' ``REQUIRED'', ``SHOULD'', ``RECOMMENDED'',
and ``MAY'' in this document are to be interpreted as described in
RFC 2119.
2 - Protocol changes:
This document updates [RFC2535] and [RFC2874], by adding new
requirements.
All RFC2535-compliant servers and resolvers MUST support EDNS0 and
advertise message size of at least 1220 octets, but SHOULD advertise
message size of 4000. This value might be too low to get full
answers for high level servers and successor of this document may
require a larger value.
All RFC2874-compliant servers and resolver MUST support EDNS0 and
advertise message size of at least 1024 octets, but SHOULD advertise
message size of 2048. The IPv6 datagrams should be 1024 octets,
unless the MTU of the path is known.
All RFC2535 and RFC2874 compliant entities MUST be able to handle
fragmented IP and IPv6 UDP packets.
All hosts supporting both RFC2535 and RFC2874 MUST use the larger
required value in EDNS0 advertisements.
3 Acknowledgments
Harald Alvestrand, Rob Austein, Randy Bush, David Conrad, Andreas
Gustafsson, Jun-ichiro itojun Hagino, Bob Halley, Edward Lewis and
Kazu Yamamoto where instrumental in motivating and shaping this
document.
Expires July 2001 [Page 4]
INTERNET-DRAFT DNSSEC and IPng message size requirement January 2001
4 - Security Considerations:
There are no additional security considerations other than those in
RFC2671.
5 - IANA Considerations:
None
References:
[RFC1034] P. Mockapetris, ``Domain Names - Concepts and Facilities''
STD 13, RFC 1034, November 1987.
[RFC1035] P. Mockapetris, ``Domain Names - Implementation and
Specification'', STD 13, RFC 1035, November 1987.
[RFC2535] D. Eastlake, ``Domain Name System Security Extensions'', RFC
2535, March 1999.
[RFC2671] P. Vixie, ``Extension Mechanisms for DNS (EDNS0)'', RFC
2671, August 1999.
[RFC2845] P. Vixie, O. Gudmundsson, D. Eastlake, B. Wellington,
``Secret Key Transaction Authentication for DNS (TSIG)'', RFC
2845, May 2000.
[RFC2874] M. Crawford, C. Huitema, ``DNS Extensions to Support IPv6
Address Aggregation and Renumbering'', RFC2874, July 2000.
[OK] D. Conrad, ``Indicating Resolver Support of DNSSEC'', Work in
progress, draft-ietf-dnsext-dnssec-okbit-xx.txt, November
2000.
Expires July 2001 [Page 5]
INTERNET-DRAFT DNSSEC and IPng message size requirement January 2001
Author Address
Olafur Gudmundsson
NAI Labs
Network Associates
3060 Washington Road (Rt. 97)
Glenwood, MD 21738
USA
<ogud@tislabs.com>
Full Copyright Statement
Copyright (C) The Internet Society (2001). All Rights Reserved.
This document and translations of it may be copied and furnished to
others, and derivative works that comment on or otherwise explain it
or assist in its implementation may be prepared, copied, published
and distributed, in whole or in part, without restriction of any
kind, provided that the above copyright notice and this paragraph are
included on all such copies and derivative works. However, this
document itself may not be modified in any way, such as by removing
the copyright notice or references to the Internet Society or other
Internet organizations, except as needed for the purpose of
developing Internet standards in which case the procedures for
copyrights defined in the Internet Standards process must be
followed, or as required to translate it into languages other than
English.
The limited permissions granted above are perpetual and will not be
revoked by the Internet Society or its successors or assigns.
This document and the information contained herein is provided on an
"AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE."
Expires July 2001 [Page 6]