FECFRAME Working Group Watson
Internet-Draft Digital Fountain
Expires: January 1, 2007 June 30, 2006
FECFRAME requirements
draft-ietf-fecframe-req-00
Status of this Memo
By submitting this Internet-Draft, each author represents that any
applicable patent or other IPR claims of which he or she is aware
have been or will be disclosed, and any of which he or she becomes
aware will be disclosed, in accordance with Section 6 of BCP 79.
Internet-Drafts are working documents of the Internet Engineering
Task Force (IETF), its areas, and its working groups. Note that
other groups may also distribute working documents as Internet-
Drafts.
Internet-Drafts are draft documents valid for a maximum of six months
and may be updated, replaced, or obsoleted by other documents at any
time. It is inappropriate to use Internet-Drafts as reference
material or to cite them other than as "work in progress."
The list of current Internet-Drafts can be accessed at
http://www.ietf.org/ietf/1id-abstracts.txt.
The list of Internet-Draft Shadow Directories can be accessed at
http://www.ietf.org/shadow.html.
This Internet-Draft will expire on January 1, 2007.
Copyright Notice
Copyright (C) The Internet Society (2006).
Abstract
This document defines requirements for a "FEC Framework" to be
defined by the IETF FECFRAME working group. The object of this group
is primarily to develop specifications for using forward error
correction (FEC) codes with applications in the Internet to provide
protection against packet loss.
Watson Expires January 1, 2007 [Page 1]
Internet-Draft FECFRAME requirements June 2006
Table of Contents
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . 3
2. Terminology . . . . . . . . . . . . . . . . . . . . . . . . . 5
3. Essential requirements . . . . . . . . . . . . . . . . . . . . 6
4. Non-essential requirements . . . . . . . . . . . . . . . . . . 8
5. Security Considerations . . . . . . . . . . . . . . . . . . . 9
6. References . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Author's Address . . . . . . . . . . . . . . . . . . . . . . . . . 10
Intellectual Property and Copyright Statements . . . . . . . . . . 11
Watson Expires January 1, 2007 [Page 2]
Internet-Draft FECFRAME requirements June 2006
1. Introduction
This document defines requirements for a "FEC Framework" to be
defined by the IETF FECFRAME working group. The purpose of this
working group is defined in the working group charter as follows:
"The object of this group is to develop specifications for using
forward error correction (FEC) codes with applications in the
Internet to provide protection against packet loss. The group
will develop a protocol framework for application of FEC codes to
arbitrary packet flows over unreliable transport protocols over
both IP multicast and unicast."
This document defines requirements for this protocol framework. Both
'essential' ('SHALL') and 'non-essential' ('SHOULD') requirements are
considered.
A 'protocol framework' is a partial specification of a protocol,
along with a formal description of the missing aspects which are
required to form a full protocol specification - i.e. a protocol
framework is a protocol with 'holes' and a detailed description of
the 'shape' of those holes. Protocol frameworks provide for maximum
commonality between different complete protocols which provide
similar functions and therefore simplify implementation and
understanding of a set of alternative protocols which perform similar
functions. In this case, support for different complete protocols is
valuable for two reasons. Firstly because there exist many different
forward error correction codes, with different properties in terms of
error correction capability, computational complexity, flexibility
and intellectual property rights. Secondly, there are many
applications which could benefit from the use of forward error
correction. The FEC framework therefore replaces the "full mesh" of
application/FEC code combinations with a single general approach
which specifies how any FEC code meeting the FEC code requirments
defined in the framework can be used with any application meeting the
application requirements defined in the framework.
The FEC protocol framework must therefore define as much as possible
of a protocol for providing forward error correction for arbitrary
packet flows over unreliable transport, without defining a particular
FEC code or assuming a particular application. Furthermore, the
protocol framework specification will define a clear interface
between the specified parts and the unspecified, FEC-code-specific
and application-specific, parts. For this purpose, the building
block techniques applied in the Reliable Multicast (RMT) working
group will be re-used, specifically the FEC Building Block [I-D.ietf-
rmt-fec-bb-revised]
Watson Expires January 1, 2007 [Page 3]
Internet-Draft FECFRAME requirements June 2006
The term "Forward Error Correction" refers here to application/
transport layer techniques for recovering lost packets of data. More
accurately, the term "Forward Erasure Correction" should be used. In
many contexts the term "Application Layer FEC (AL-FEC)" is also used,
although the mechanisms considered here could be considered as either
application or transport layer (the important point being that they
are end-to-end).
Generally, an "FEC Code" is defined in terms of the operations
required to construct encoded data from source data (at an encoder)
and to reconstruct source data from encoded data (at a decoder). In
order to apply an FEC Code to arbitrary packet flows, additional
elements are required such as protocol elements to identify encoded
data within packets, pre-processing of source data (e.g. segmentation
and/or addition of FEC-related indications into the source data).
Therefore, in order to adapt an FEC Code for use in the context of
the FEC Framework, additional FEC-code specific specification is
required. Following the approach of the FEC Building Block, this
specification is known as an "FEC Scheme". The FEC Framework will
define the requirements that FEC Schemes must meet for use with the
framework.
Generally, it is required to add forward error correction to existing
applications, for example media streaming applications. In this
case, the application protocols must be extended to support this.
The FEC framework will describe the requirements that application
protocols must meet in order to be used with the FEC framework.
This version of this document is a first draft for discussion in the
FECFRAME working group.
Watson Expires January 1, 2007 [Page 4]
Internet-Draft FECFRAME requirements June 2006
2. Terminology
'FEC' Forward Erasure Correction.
'AL-FEC' Application Layer Forward Erasure Correction
'FEC Framework' The protocol framework which is to be defined by
FECFRAME and for which this document provides requirements.
'Source data flow' The packet flow or flows to which FEC protection
is to be applied.
'Repair data flow' The packet flow or flows carrying forward error
correction data
'Source protocol' A protocol used for the source data flow being
protected - e.g. RTP.
'Transport protocol' The protocol used for transport of the source
data flow being protected - e.g. UDP, DCCP.
'Application protocol' Control protocols used to establish and modify
the source data flow being protected - e.g. RTSP.
'FEC Code' An algorithm for encoding data such that the encoded dats
flow is resiliant to data loss or corruption.
'FEC Scheme' A specification which defines the additional protocol
aspects required to use a particular FEC code with the FEC
framework, or (in the context of RMT), with the RMT FEC Building
Block.
'Source Block' the group of source data packets which are to be FEC
protected as a single block
'Protection amount' The relative increase in data sent due to the use
of FEC.
Watson Expires January 1, 2007 [Page 5]
Internet-Draft FECFRAME requirements June 2006
3. Essential requirements
Req-10: The FEC Framework shall support a wide range of FEC codes,
using the abstractions of the FEC Building Block defined in RMT
[I-D.ietf-rmt-fec-bb-revised] (including short and long block FEC
codes, systematic and non-systematic codes). Specifically, the
FEC Framework shall define the requirements that FEC code
specifications shall meet in order to be used with the framework,
re-using, as far as possible, the FEC code specification approach
and requirements from the FEC Building Block and specifying any
further requirements that must be met for the FEC Framework.
Req-20: The FEC Framework shall support a wide range of application
protocols, using the abstractions of the FEC Building Block
[I-D.ietf-rmt-fec-bb-revised]. Specifically, the FEC Framework
shall define the requirements that application protocol
specifications shall meet in order to be used with the framework,
re-using, as far as possible, the Content Delivery Protocol
specification approach and requirements from the FEC Building
Block and specifying any further requirements that must be met for
the FEC Framework.
Req-30: The FEC Framework shall support variable source block sizes,
including real-time variation of source block size between blocks
of a given source data flow.
Req-30: The FEC Framework shall support variable protection amounts,
including real-time variation of protection amount between blocks
within a given source data flow.
Req-40: The FEC Framework shall be independent of the source
protocols (provided that source protocol uses one of the supported
transport protocols).
Req-50: The FEC Framework shall place minimal requirements on the
application protocols.
Req-60: The FEC Framework shall support variable source data flow
rates.
Req-70: The FEC Framework shall support variable source data flow
packet sizes.
Req-80: The FEC Framework shall provide support of combined
protection of multiple source data flows.
Watson Expires January 1, 2007 [Page 6]
Internet-Draft FECFRAME requirements June 2006
Req-90: The FEC Framework shall provide support of multiple transport
protocols for the source data protocols (UDP, DCCP, others ?).
Req-100: The FEC Framework shall provide support for definition of
backwards-compatible FEC protocols (i.e. where the source packets
are not modified in any way).
Req-110: The FEC Framework shall provide support for different source
data protocols (RTP, MIKEY, others ?).
Req-120: The FEC Framework shall shall address the security issues,
if any, associated with the use of FEC.
Watson Expires January 1, 2007 [Page 7]
Internet-Draft FECFRAME requirements June 2006
4. Non-essential requirements
The FEC Framework should be constructed such that the FEC
streaming protocol defined by 3GPP in TS26.346 is a valid protocol
according to the FEC Framework.
Watson Expires January 1, 2007 [Page 8]
Internet-Draft FECFRAME requirements June 2006
5. Security Considerations
This document defines requirements for the work of the FECFRAME
working group and includes a requirement that the security
implications of the use of FEC, if any, should be addressed in that
work.
6. References
[I-D.ietf-rmt-fec-bb-revised]
Watson, M., "Forward Error Correction (FEC) Building
Block", draft-ietf-rmt-fec-bb-revised-03 (work in
progress), January 2006.
Watson Expires January 1, 2007 [Page 9]
Internet-Draft FECFRAME requirements June 2006
Author's Address
Mark Watson
Digital Fountain
39141 Civic Center Dr.
Suite 300
Fremont, CA 94538
US
Email: mark@digitalfountain.com
Watson Expires January 1, 2007 [Page 10]
Internet-Draft FECFRAME requirements June 2006
Intellectual Property Statement
The IETF takes no position regarding the validity or scope of any
Intellectual Property Rights or other rights that might be claimed to
pertain to the implementation or use of the technology described in
this document or the extent to which any license under such rights
might or might not be available; nor does it represent that it has
made any independent effort to identify any such rights. Information
on the procedures with respect to rights in RFC documents can be
found in BCP 78 and BCP 79.
Copies of IPR disclosures made to the IETF Secretariat and any
assurances of licenses to be made available, or the result of an
attempt made to obtain a general license or permission for the use of
such proprietary rights by implementers or users of this
specification can be obtained from the IETF on-line IPR repository at
http://www.ietf.org/ipr.
The IETF invites any interested party to bring to its attention any
copyrights, patents or patent applications, or other proprietary
rights that may cover technology that may be required to implement
this standard. Please address the information to the IETF at
ietf-ipr@ietf.org.
Disclaimer of Validity
This document and the information contained herein are provided on an
"AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Copyright Statement
Copyright (C) The Internet Society (2006). This document is subject
to the rights, licenses and restrictions contained in BCP 78, and
except as set forth therein, the authors retain all their rights.
Acknowledgment
Funding for the RFC Editor function is currently provided by the
Internet Society.
Watson Expires January 1, 2007 [Page 11]
