A new Request for Comments is now available in online RFC libraries. RFC 3590 Title: Source Address Selection for the Multicast Listener Discovery (MLD) Protocol Author(s): B. Haberman Status: Standards Track Date: September 2003 Mailbox: firstname.lastname@example.org Pages: 6 Characters: 11554 Updates: 2710 I-D Tag: draft-ietf-magma-mld-source-07.txt URL: ftp://ftp.rfc-editor.org/in-notes/rfc3590.txt It has come to light that there is an issue with the selection of a suitable IPv6 source address for Multicast Listener Discovery (MLD) messages when a node is performing stateless address autoconfiguration. This document is intended to clarify the rules on selecting an IPv6 address to use for MLD messages. This document is a product of the Multicast & Anycast Group Membership Working Group of the IETF. This is now a Proposed Standard Protocol. This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. This announcement is sent to the IETF list and the RFC-DIST list. Requests to be added to or deleted from the IETF distribution list should be sent to IETF-REQUEST@IETF.ORG. Requests to be added to or deleted from the RFC-DIST distribution list should be sent to RFC-DIST-REQUEST@RFC-EDITOR.ORG. Details on obtaining RFCs via FTP or EMAIL may be obtained by sending an EMAIL message to rfc-info@RFC-EDITOR.ORG with the message body help: ways_to_get_rfcs. For example: To: rfc-info@RFC-EDITOR.ORG Subject: getting rfcs help: ways_to_get_rfcs Requests for special distribution should be addressed to either the author of the RFC in question, or to RFC-Manager@RFC-EDITOR.ORG. Unless specifically noted otherwise on the RFC itself, all RFCs are for unlimited distribution.echo Submissions for Requests for Comments should be sent to RFC-EDITOR@RFC-EDITOR.ORG. Please consult RFC 2223, Instructions to RFC Authors, for further information.