Network Working Group Luca Martini
Internet Draft
Expiration Date: December 2005 Cisco Systems Inc.
June 2005
IANA Allocations for pseudo Wire Edge to Edge Emulation (PWE3)
draft-ietf-pwe3-iana-allocation-11.txt
Status of this Memo
By submitting this Internet-Draft, each author represents that any
applicable patent or other IPR claims of which he or she is aware
have been or will be disclosed, and any of which he or she becomes
aware will be disclosed, in accordance with Section 6 of BCP 79.
Internet-Drafts are working documents of the Internet Engineering
Task Force (IETF), its areas, and its working groups. Note that other
groups may also distribute working documents as Internet-Drafts.
Internet-Drafts are draft documents valid for a maximum of six months
and may be updated, replaced, or obsoleted by other documents at any
time. It is inappropriate to use Internet-Drafts as reference
material or to cite them other than as "work in progress."
The list of current Internet-Drafts can be accessed at
http://www.ietf.org/1id-abstracts.html
The list of Internet-Draft Shadow Directories can be accessed at
http://www.ietf.org/shadow.html.
Abstract
The Control and maintenance protocol for providing various Layer 1
and Layer 2 services over a Packet Switched Network has been
described in [1]. This document pre-allocates the fixed Pseudo-wire
identifier , and other fixed protocol values that are to be assigned
by IANA using the "IETF Consensus" policy defined in RFC2434
Martini [Page 1]
Internet Draft draft-ietf-pwe3-iana-allocation-11.txt June 2005
Table of Contents
1 Specification of Requirements .......................... 2
2 IANA Considerations .................................... 2
2.1 Pseudowire Type ........................................ 2
2.2 Interface Parameters Sub-TLV type ...................... 4
2.3 Attachment Identifiers ................................. 5
2.3.1 Attachment Individual Identifier Type .................. 5
2.3.2 Attachment Group Identifier (AGI) Type ................. 5
2.4 Pseudo Wire Status ..................................... 5
3 Security Considerations ................................ 6
4 Full Copyright Statement ............................... 6
5 Intellectual Property Statement ........................ 6
6 Author Information ..................................... 7
1. Specification of Requirements
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in RFC 2119
2. IANA Considerations
Unless otherwise noted in this document, the value of 0 is reserved,
and MUST not be used.
2.1. Pseudowire Type
IANA needs to set up a registry of "Pseudowire Type". These are 15-
bit values. PW Type values 1 through 127 are to be assigned by IANA
using the "IETF Consensus" policy defined in RFC2434. PW Type values
128 through 32767 are to be assigned by IANA, using the "First Come
First Served" policy defined in RFC2434. In addition to the "First
Come First Served" policy, an internet draft describing the intended
use for the code point to be allocated, MUST exists at the time of
allocation. This internet draft MAY be targeted to become an
informational RFC, but in any case the allocation will not depend in
any way on the status of the internet draft. A Pseudowire Type
description of up to 65 characters is required for any assignment
from this registry. The registry MUST contain the name of the
Martini [Page 2]
Internet Draft draft-ietf-pwe3-iana-allocation-11.txt June 2005
internet draft at the time of code point allocation.
Initial Pseudowire type value allocations are specified below:
PW type Description
0x0001 Frame Relay DLCI ( Martini Mode )
0x0002 ATM AAL5 SDU VCC transport
0x0003 ATM transparent cell transport
0x0004 Ethernet Tagged Mode
0x0005 Ethernet
0x0006 HDLC
0x0007 PPP
0x0008 SONET/SDH Circuit Emulation Service Over MPLS(CEM) [Note1]
0x0009 ATM n-to-one VCC cell transport
0x000A ATM n-to-one VPC cell transport
0x000B IP Layer2 Transport
0x000C ATM one-to-one VCC Cell Mode
0x000D ATM one-to-one VPC Cell Mode
0x000E ATM AAL5 PDU VCC transport
0x000F Frame-Relay Port mode
0x0010 SONET/SDH Circuit Emulation over Packet (CEP)
0x0011 Structure-agnostic E1 over Packet (SAToP)
0x0012 Structure-agnostic T1 (DS1) over Packet (SAToP)
0x0013 Structure-agnostic E3 over Packet (SAToP)
0x0014 Structure-agnostic T3 (DS3) over Packet (SAToP)
0x0015 CESoPSN basic mode
0x0016 TDMoIP AAL1 Mode
0x0017 CESoPSN TDM with CAS
0x0018 TDMoIP AAL2 Mode
0x0019 Frame Relay DLCI
0x001A cTCP (RFC1144) Transport Header-compressed Packets
0x001B IPHC (RFC2507) Transport Header-compressed Packets
0x001C cRTP (RFC2508) Transport Header-compressed Packets
0x001D ROHC (RFC3095) Transport Header-compressed Packets
0x001E eCRTP (RFC3545) Transport Header-compressed Packets
Note 1: This PW type is grandfathered for a historical protocol. The
recommended standards-track protocol to use is CEP (PW type 0x0010).
Martini [Page 3]
Internet Draft draft-ietf-pwe3-iana-allocation-11.txt June 2005
2.2. Interface Parameters Sub-TLV type
IANA needs to set up a registry of "Pseudowire Interface Parameter
Sub-TLV types". Sub-TLV types 1 through 127 are to be assigned by
IANA using the "IETF Consensus" policy defined in RFC2434. Sub-TLV
types 128 through 255 are to be assigned by IANA, using the "First
Come First Served" policy defined in RFC2434. In addition to the
"First Come First Served" policy, an internet draft describing the
intended use for the code point to be allocated, MUST exists at the
time of allocation. This internet draft MAY be targeted to become an
informational RFC, but in any case the allocation will not depend in
any way on the status of the internet draft. The registry MUST
contain the name of the internet draft at the time of code point
allocation.
Any assignments requested from this registry require a description up
to 54 characters. Furthermore a length specified as follows:
- A decimal integer
- Text as follows:"up to X", where X is a decimal integer
- Up to 3 different decimal integers.
is also required for assignment from this registry.
Initial Pseudowire Interface Parameter Sub-TLV type allocations are
specified below:
Parameter ID Length Description
0x01 4 Interface MTU in octets
0x02 4 Maximum Number of concatenated ATM cells
0x03 up to 82 Optional Interface Description string
0x04 4 CEP/TDM Payload Bytes
0x05 4 CEP options
0x06 4 Requested VLAN ID
0x07 6 CEP/TDM bit-rate
0x08 4 Frame-Relay DLCI Length
0x09 4 Fragmentation indicator
0x0A 4 FCS retention indicator
0x0B 4/8/12 TDM options
0x0C 4 VCCV parameter
Note that the Length field is defined as the length of the Sub-TLV
including the Sub-TLV type and length field itself.
Martini [Page 4]
Internet Draft draft-ietf-pwe3-iana-allocation-11.txt June 2005
2.3. Attachment Identifiers
2.3.1. Attachment Individual Identifier Type
IANA needs to set up a registry of "Attachment Individual Identifier
(AII) Type". These are 8-bit values. AII Type values 1 through 127
are to be assigned by IANA using the "IETF Consensus" policy defined
in RFC2434. AII Type values 128 through 255 are to be assigned by
IANA, using the "First Come First Served" policy defined in RFC2434.
In addition to the "First Come First Served" policy, an internet
draft describing the intended use for the code point to be allocated,
MUST exists at the time of allocation. This internet draft MAY be
targeted to become an informational RFC, but in any case the
allocation will not depend in any way on the status of the internet
draft. The registry MUST contain the name of the internet draft at
the time of code point allocation. An AII Type description of up to
65 characters is required for any assignment from this registry.
2.3.2. Attachment Group Identifier (AGI) Type
IANA needs to set up a registry of "Attachment Group Identifier (AGI)
Type". These are 8-bit values. AGI Type values 1 through 127 are to
be assigned by IANA using the "IETF Consensus" policy defined in
RFC2434. AGI Type values 128 through 255 are to be assigned by IANA,
using the "First Come First Served" policy defined in RFC2434. In
addition to the "First Come First Served" policy, an internet draft
describing the intended use for the code point to be allocated, MUST
exists at the time of allocation. This internet draft MAY be targeted
to become an informational RFC, but in any case the allocation will
not depend in any way on the status of the internet draft. The
registry MUST contain the name of the internet draft at the time of
code point allocation. AGI Type description of up to 65 characters is
required for any assignment from this registry.
2.4. Pseudo Wire Status
IANA needs to set up a registry of "Pseudowire Status Codes". These
are bitstrings of length 32. Status bits 0-23 are to be assigned by
IANA using the "IETF Consensus" policy defined in RFC2434. PW Status
Bits 24 through 31 are to be assigned by IANA, using the "First Come
First Served" policy defined in RFC2434. In addition to the "First
Come First Served" policy, an internet draft describing the intended
use for the code point to be allocated, MUST exists at the time of
allocation. This internet draft MAY be targeted to become an
informational RFC, but in any case the allocation will not depend in
any way on the status of the internet draft. The registry MUST
Martini [Page 5]
Internet Draft draft-ietf-pwe3-iana-allocation-11.txt June 2005
contain the name of the internet draft at the time of code point
allocation. Any requests for allocation from this registry must
include a 65 character description. Initial Pseudowire Status Codes
value allocations are as follows:
0x00000000 - Pseudo Wire forwarding ( clear all failures )
0x00000001 - Pseudo Wire Not Forwarding
0x00000002 - Local Attachment Circuit ( ingress ) Receive Fault
0x00000004 - Local Attachment Circuit ( egress ) Transmit Fault
0x00000008 - Local PSN-facing PW ( ingress ) Receive Fault
0x00000010 - Local PSN-facing PW ( egress ) Transmit Fault
3. Security Considerations
This document specifies only fixed identifiers, and not the protocols
used to carry the encapsulated packets across the network. Each such
protocol may have its own set of security issues, but those issues
are not affected by the identifiers specified herein.
4. Full Copyright Statement
Copyright (C) The Internet Society (2005). This document is subject
to the rights, licenses and restrictions contained in BCP 78, and
except as set forth therein, the authors retain all their rights.
This document and the information contained herein are provided on an
"AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
5. Intellectual Property Statement
The IETF takes no position regarding the validity or scope of any
Intellectual Property Rights or other rights that might be claimed to
pertain to the implementation or use of the technology described in
this document or the extent to which any license under such rights
might or might not be available; nor does it represent that it has
made any independent effort to identify any such rights. Information
on the procedures with respect to rights in RFC documents can be
found in BCP 78 and BCP 79.
Copies of IPR disclosures made to the IETF Secretariat and any
Martini [Page 6]
Internet Draft draft-ietf-pwe3-iana-allocation-11.txt June 2005
assurances of licenses to be made available, or the result of an
attempt made to obtain a general license or permission for the use of
such proprietary rights by implementers or users of this
specification can be obtained from the IETF on-line IPR repository at
http://www.ietf.org/ipr.
The IETF invites any interested party to bring to its attention any
copyrights, patents or patent applications, or other proprietary
rights that may cover technology that may be required to implement
this standard. Please address the information to the IETF at ietf-
ipr@ietf.org.
By submitting this Internet-Draft, I certify that any applicable
patent or other IPR claims of which I am aware have been disclosed,
or will be disclosed, and any of which I become aware will be
disclosed, in accordance with RFC 3668.
6. Author Information
Luca Martini
Cisco Systems, Inc.
9155 East Nichols Avenue, Suite 400
Englewood, CO, 80112
e-mail: lmartini@cisco.com
Martini [Page 7]