Last Call Review of draft-ietf-nvo3-evpn-applicability-03
review-ietf-nvo3-evpn-applicability-03-rtgdir-lc-chen-2022-06-02-00

Comments:
This document is well-written and easy to read. It gives a detail introduction
on how to apply EVPN to NVO3 networks.

Nits:
1. Section 4.2, Figure 1
Where the BD1 is depicted as part of MAC-VRF1, but according to the definition
of BD and MAC-VRF, there should not be inclusion relationship between BD and
MAC-VRF. To avoid confusion, I'd suggest to remove the MAC-VRF1 from NVE1. In
addition, Figure uses "-" and "=" to describe active ACs, it's better to use
either "-" or "=", instead of using both.

In addition, suggest to add a reference to MP-BGP.

2. Section 4.2.1,
Suggest to add a reference to LACP.

3. Section 4.2.2,
OLD:
"In the example of Figure 1, when MAC-VRF1/BD1 are enabled, NVE1 will
   send an RT-3 including its own IP address, Ethernet-Tag for BD1 and
   the PTA.  Assuming Ingress Replication (IR), the RT-3 will include an
   identification for IR in the PTA and the VNI the NVEs must use to
   send BUM traffic to the advertising NVE."
New:
"In the example of Figure 1, when MAC-VRF1/BD1 are enabled, NVE1 will
   send an RT-3 including its own IP address, Ethernet-Tag for BD1 and
   the PTA to the remote NVEs.  Assuming Ingress Replication (IR) is used,
   the RT-3 will include an identification for IR in the PTA and the VNI that
   the other NVEs in the BD must use to send BUM traffic to the advertising
   NVE."

s/NVEs participating/the NVEs participating

s/RT-3/RT-3 route, it needs to check the whole document for the similar
situation, for each RT-x, a "route" should be added after it.

4. Section 4.3
s/Asymmetric and Symmetric/Asymmetric and Symmetric model

5. Section 4.5,
The section title, s/EVPN OAM and application to NVO3/EVPN OAM and Application
to NVO3, it needs to check the whole document to make sure that that section
title adopts consistent style, e.g., upper case for each word.

6. Section 4.6,
Is it just in theory or is there an existing extension? If latter, a reference
is preferred; otherwise, maybe it can be safely removed or add some text to say
that there will be potential work to do.

7. Section 4.7.6,
It's better to add "SBD" to the Terminology section and add more text to
describe it.