Signaling Entropy Label Capability and Entropy Readable Label Depth Using IS-IS
RFC 9088
Yes
No Objection
Note: This ballot was opened for revision 12 and is now closed.
Alvaro Retana Yes
Erik Kline No Objection
[[ nits ]] [ section 1 ] * "(e.g., SR-MPLS [...]," appears to lack a closing parenthesis.
Martin Duke No Objection
Murray Kucherawy No Objection
What Barry said. Also, I presume your AD has approved going over the usual limit of five authors.
Robert Wilton No Objection
Hi, Same comment as for equivalent OSPF draft. Is there any associated YANG module required to manage this protocol enhancement? If so, is that already being worked or, or planned work for the WG? Regards, Rob
Roman Danyliw No Objection
Two editorial nits: ** Section 3. Editorial. s/ When a router propagates a prefix between ISIS levels ([RFC5302],/When a router propagates a prefix between ISIS levels [RFC5302],/ ** Section 4. Figure 2. The text says that “A MSD-Type Code 2 has been assigned by IANA”, but Figure 2 says “MSD-Type=TBD2”.
Warren Kumari No Objection
I had the weirdest sense of deja vu when reviewing this document -- enough that I went back to see if it had been on a previous telechat -- and then realized that it was the IS-IS version of draft-ietf-ospf-mpls-elc :-)
Éric Vyncke No Objection
Thank you for the work put into this document. The document is easy to read. Like other ADs, I wonder why the IS-IS and OSPF are separate documents. Please find below one NIT. I hope that this helps to improve the document, Regards, -éric == NIT == -- section 4 -- The "one" is ambiguous in "the router MUST advertise the smallest one." even if we can guess that it is not "interface" ;-)
(Alissa Cooper; former steering group member) No Objection
(Barry Leiba; former steering group member) No Objection
Just a few editorial nits: — Section 1 — In cases where LSPs are used (e.g., SR-MPLS [RFC8660], it would be Nit: you need a closing parenthesis instead of the second comma. This capability, referred to as Entropy Readable Label Depth (ERLD) as defined in [RFC8662] may be used by ingress LSRs to Nit: this needs a comma after the citation. — Section 3 — originator. Similarly in a multi-domain network, the identity of the Nit: “Similarly” needs a comma after it. When a router propagates a prefix between ISIS levels ([RFC5302], it Nit: remove the open parenthesis. an Autonomous System Boundary Router (ASBR) is outside of the scope Nit: the abbreviation “ASBR” is not used elsewhere in the document, so there’s no reason to include it. — Section 4 — A new MSD-type [RFC8491], called ERLD-MSD is defined to advertise the Nit: 8491 capitalizes the “T” in “MSD-Type”. Nit: there needs to be a comma after “ERLD-MSD”.
(Benjamin Kaduk; former steering group member) (was Discuss) No Objection
Thank you for educating me, and addressing the minor residual remains of my discuss point that were left after that, as well as my comments.
(Deborah Brungard; former steering group member) No Objection
(Magnus Westerlund; former steering group member) No Objection
(Martin Vigoureux; former steering group member) No Objection