Skip to main content

Performance Measurement Using Simple TWAMP (STAMP) for Segment Routing Networks
draft-gandhi-spring-stamp-srpm-07

Document Type Replaced Internet-Draft (spring WG)
Expired & archived
Authors Rakesh Gandhi , Clarence Filsfils , Daniel Voyer , Mach Chen , Bart Janssens , Richard "Footer" Foote
Last updated 2021-07-06
Replaces draft-gandhi-spring-rfc6374-srpm-udp, draft-gandhi-spring-twamp-srpm
Replaced by draft-ietf-spring-stamp-srpm
RFC stream Internet Engineering Task Force (IETF)
Intended RFC status (None)
Formats
Additional resources Mailing list discussion
Stream WG state Waiting for WG Chair Go-Ahead
Document shepherd (None)
IESG IESG state Replaced by draft-ietf-spring-stamp-srpm
Consensus boilerplate Unknown
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

Segment Routing (SR) leverages the source routing paradigm. SR is applicable to both Multiprotocol Label Switching (SR-MPLS) and IPv6 (SRv6) data planes. This document describes procedures for Performance Measurement in SR networks using the mechanisms defined in RFC 8762 (Simple Two-Way Active Measurement Protocol (STAMP)) and its optional extensions defined in RFC 8972 and further augmented in draft-ietf-ippm-stamp-srpm. The procedure described is applicable to SR-MPLS and SRv6 data planes and is used for both links and end-to- end SR paths including SR Policies.

Authors

Rakesh Gandhi
Clarence Filsfils
Daniel Voyer
Mach Chen
Bart Janssens
Richard "Footer" Foote

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)