RADIUS Attributes for Multilink PPP Banwidth Allocation Control
draft-ietf-radius-ms-ba-attr-01
Document | Type |
Expired Internet-Draft
(radius WG)
Expired & archived
|
|
---|---|---|---|
Author | Glen Zorn | ||
Last updated | 1998-02-25 | ||
RFC stream | Internet Engineering Task Force (IETF) | ||
Intended RFC status | (None) | ||
Formats | |||
Additional resources | Mailing list discussion | ||
Stream | WG state | WG Document | |
Document shepherd | (None) | ||
IESG | IESG state | Expired | |
Consensus boilerplate | Unknown | ||
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes a set of vendor-specific RADIUS attributes designed to support the dynamic control of bandwidth allocation in mul- tilink PPP [1]. Attributes are defined that specify whether use of the PPP Bandwidth Allocation Protocol [2] is allowed or required on incoming calls, the level of line capacity (expressed as a percentage) below which utilization must fall before a link is eligible to be dropped, and the length of time (in seconds) that a link must be underutilized before it is dropped.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)