TRILL Routing Requirements in Support of RBridges
draft-ietf-trill-routing-reqs-02
Document | Type |
Expired Internet-Draft
(trill WG)
Expired & archived
|
|
---|---|---|---|
Author | Eric W. Gray | ||
Last updated | 2015-10-14 (Latest revision 2007-02-01) | ||
Replaces | draft-gray-trill-routing-reqs | ||
RFC stream | Internet Engineering Task Force (IETF) | ||
Intended RFC status | Informational | ||
Formats | |||
Reviews | |||
Additional resources | Mailing list discussion | ||
Stream | WG state | WG Document | |
Document shepherd | (None) | ||
IESG | IESG state | Expired (IESG: Dead) | |
Action Holders |
(None)
|
||
Consensus boilerplate | Unknown | ||
Telechat date | (None) | ||
Responsible AD | Mark Townsley | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
RBridges provide the ability to have an entire domain, with multiple physical links, look to IP like a single subnet. The design allows for zero configuration of switches within an RBridge domain, optimal pair-wise routing, safe forwarding even during periods of temporary loops, and potential additional advantages as well. The design also supports VLANs, allows forwarding tables to be based on destinations within the RBridge domain (rather than station destinations, allowing internal forwarding tables to be smaller than in conventional bridge systems). The intent is to re-uses one or more existing routing protocols to accomplish these goals. This document lays out the background and specific requirements of potential routing protocols to be considered for use in this design. In particular, this document defines what is needed to accomodate this design using IS-IS (or OSPF) as a basis for RBridge protocols.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)