Skip to main content

Network based IP VPN Architecture Using Virtual Routers
draft-ietf-l3vpn-vpn-vr-03

Document Type Withdrawn by IETF Internet-Draft (l3vpn WG)
Expired & archived
Author Hamid H. Ould-Brahim
Last updated 2007-05-07 (Latest revision 2006-03-06)
RFC stream Internet Engineering Task Force (IETF)
Intended RFC status Informational
Formats
Additional resources Mailing list discussion
Stream WG state WG Document
Document shepherd (None)
IESG IESG state Withdrawn by IETF (IESG: Dead)
Action Holders
(None)
Consensus boilerplate Unknown
Telechat date (None)
Responsible AD Mark Townsley
Send notices to rick@rhwilder.net, rcallon@juniper.net, rbonica@juniper.net, ananth@juniper.net, suzuki.muneyoshi@lab.ntt.co.jp, j.sumimoto@ntt.com, bensons@savvis.net

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document describes a network-based Virtual Private Network (VPN) architecture using the virtual router (VR) concept. Multiple VRs can exist in a single physical device. A VR emulates all the functionality of a physical router, and therefore inherits all existing mechanisms and tools for configuration, operation, accounting, and maintenance. Any routing protocol can be used to distribute VPN reachability information among VRs, and no VPN- related modifications or extensions are needed to the routing protocol for achieving VPN reachability. Direct VR-to-VR connectivity may be configured through layer-2 links or through IP- or MPLS-based tunnels. Traffic from VRs belonging to different VPNs may be aggregated over a "backbone VR" network, which greatly simplifies VPN provisioning. This architecture accommodates various backbone deployment scenarios, both where the VPN service provider owns the backbone, and where the VPN service provider obtains backbone service from one or more other service providers.

Authors

Hamid H. Ould-Brahim

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)