Pseudowire And LDP-enabled Services (pals)
|WG||Name||Pseudowire And LDP-enabled Services|
|Area||Routing Area (rtg)|
|Dependencies||Document dependency graph (SVG)|
|Jabber chat||Room address||xmpp:firstname.lastname@example.org?join|
Charter for Working Group
Many services that run in the Internet are facilitated in MPLS networks
by the Label Distribution Protocol (LDP) and/or are established over
pseudowires that emulate point-to-point or point-to-multipoint links and
provide communication connectivity that is perceived by its users as an
unshared link or circuit of an emulated Layer-1, Layer-2, or Layer-3
Layer-2 Virtual Private Networks (L2VPNs) are one such service that
provides an emulation of a "native" service over a packet switched
network that is adequately faithful to, but may not be entirely
indistinguishable from, the native service itself.
The Pseudowire And LDP-enabled Services (PALS) working group is
chartered to define, specify, and extend network services based on
pseudowires and/or signaled using LDP.
In particular, the working group will work on the following services:
- All types of MPLS-based and L2TPv3-based pseudowire services
including point-to-point and point-to-multipoint pseudowires, single
segment and multi-segment pseudowires, single and multi-domain
pseudowires, and signaled and statically provisioned pseudowires.
- All types of dynamic or static provider-provisioned L2VPNs that
operate over pseudowires or that are enabled over MPLS networks
using LDP as a control plane mechanism.
- IP-only L2VPN solutions (for IP-only services over a packet switched
The working group may also suggest new services to be supported by LDP
or pseudowires and these may be added to the working group charter
subject to re-chartering. The working group is also responsible for the
maintenance and development of pseudowires formerly carried out by the
PWE3 working group
The PALS working group will not define any mechanisms that exert control
over the underlying packet switched network. When necessary it may,
however, recommend or require the use of existing QoS and path control
mechanisms between the edge nodes that provide the connectivity to the
The working group may work on:
- New pseudowire encapsulations or types for services emulated over
IETF-specified Packet Switched Networks.
- Operations, Administration, and Management (OAM) for pseudowires
including interworking of OAM for pseudowires and native services, and
OAM for other services worked on by PALS (including L2VPNs). But new
techniques should be shared with the BFD and MPLS working groups to
ensure consistency with existing OAM techniques, and with the LIME
working group to provide for consistency of operation.
- Protocol extensions for LDP in support of new pseudowire function
and new services, but all protocol extensions must be reviewed by the
MPLS working group which is responsible for the consistency and
stability of LDP.
- Mechanisms to enhance pseudowire and L2VPN functionality by
including security, protection and restoration, congestion avoidance,
and load balancing across parallel packet switched tunnels.
- Mechanisms to permit optimization of multicast data traffic within an
- Enhancements to increase the scalability of the control plane and data
plane of L2VPN solutions and application of L2VPN solutions in the
data center, the latter in coordination with the NVO3 working group
- L2VPN discovery and membership mechanisms that utilize pseudowire
control and management procedures.
- Data models for modeling, managing, and operating the services worked
on by the PALS working group using SMI or YANG.
The PALS working group will not work on L2VPNs enabled using BGP, and
where L2VPNs that are within the scope of the PALS working group use
BGP to add functionality (for example for discovery of membership of a
VPN) this work will be coordinated with the BESS working group. This
also includes work on particular types of L2VPNs that support both LDP
and BGP signaling, such as VPLS. Any contention between these working
groups on the placement of such work will be resolved by the chairs.
The PALS working group will coordinate closely with the MPLS working
group for all work involving LDP and the MPLS data plane. It will also
coordinate with the MPLS working group in developing shared security,
and with the BFD and MPLS working groups on OAM solutions.
Where extensions to pseudowires are needed to support time or frequency
transfer, this work will be done by the PALS working group in
consultation with the TICTOC working group.
L2TP specifics of L2TPv3-based pseudowires will continue to be the
responsibility of the L2TPEXT working group.
|Jun 2017||Submit YANG data model for SS-PWs and MS-PWs to the IESG|
|Jun 2017||Submit L2VPN applicability statement for data center applications to the IESG|
Submit E-Tree Support in VPLS to the IESG jointly with the BESS WG
Submit PIM Snooping over VPLS to the IESG
Submit MPLS LSP PW status refresh reduction for Static PWs to the IESG
Submit P2MP PW Signaling (root initiated) to the IESG
Submit LDP-VPLS for Ethernet Broadcast and Multicast to the IESG
Submit PW Endpoint Fast Failure Protection to the IESG
Submit LDP extensions for PW Binding to LSP Tunnels to the IESG
Submit MPLS-TP PW OAM Configuration to the IESG
|Done||Submit S-PE resilience for statically provisioned MS-PWs to the IESG|
Submit MAC Address Withdrawal over Static Pseudowire to the IESG
Submit Unified Control Channel for PWs to the IESG
Submit Pseudowire Redundancy on S-PE to the IESG
Submit STP Application of ICCP to the IESG
Submit PW Congestion Considerations to the IESG