Adding a Flexible GetSize RPC Variant to the AFS-3 Volume Service
draft-deason-afs3-getsizev2-03
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Andrew Deason | ||
| Last updated | 2011-03-30 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes an additional Rx remote procedure call that may be used to obtain the size of an AFS-3 volume dump from an AFS-3 Volume Service. While an RPC already exists for this purpose (AFSVolGetSize), this document proposes a more flexible mechanism that is able to more accurately determine the size of a volume dump in a greater number of cases. Internet Draft Comments Comments regarding this draft are solicited. Please include the AFS-3 protocol standardization mailing list (afs3-standardization@openafs.org) as a recipient of any comments.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)