Quick-Start for Datagram Congestion Control Protocol (DCCP)
draft-fairhurst-tsvwg-dccp-qs-03
| Document | Type |
Replaced Internet-Draft
(individual in tsv area)
Expired & archived
|
|
|---|---|---|---|
| Author | Gorry Fairhurst | ||
| Last updated | 2024-12-18 (Latest revision 2008-05-30) | ||
| Replaced by | draft-ietf-dccp-quickstart | ||
| RFC stream | Internet Engineering Task Force (IETF) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | WG state | (None) | |
| Document shepherd | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-dccp-quickstart | |
| Consensus boilerplate | Unknown | ||
| Telechat date | (None) | ||
| Responsible AD | Lars Eggert | ||
| Send notices to | arjuna@erg.abdn.ac.uk |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document specifies the use of the Quick-Start mechanism by the Datagram Congestion Control Protocol (DCCP). DCCP is a transport protocol that allows the transmission of congestion-controlled, unreliable datagrams. DCCP is intended for applications such as streaming media, Internet telephony, and on-line games. In DCCP, an application has a choice of congestion control mechanisms, each specified by a Congestion Control Identifier (CCID). This document specifies general procedures applicable to all DCCP CCIDs and specific procedures for the use of Quick-Start with DCCP CCID-2 and CCID-3. Quick-Start enables a DCCP sender to cooperate with any Quick-Start routers along the end-to-end path to determine an allowed sending rate at the start and, at times, in the middle of a DCCP connection (e.g., after an idle or application-limited period). The present specification is provided for use in controlled environments, and not as a mechanism that would be intended or appropriate for ubiquitous deployment in the global Internet.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)