Internet-Draft P2MP Policy Ping July 2024
Bidgoli, et al. Expires 23 January 2025 [Page]
Workgroup:
Network Working Group
Internet-Draft:
draft-ietf-pim-p2mp-policy-ping-08
Published:
Intended Status:
Standards Track
Expires:
Authors:
H. Bidgoli, Ed.
Nokia
V. Voyer
Bell Canada
P. Parekh
Cisco System
Z. Zhang
Juniper Networks

P2MP Policy Ping

Abstract

SR P2MP policies are set of policies that enable architecture for P2MP service delivery. A P2MP Policy consists of candidate paths that connects the Root of the Tree to a set of Leaves. The P2MP policy is composed of replication segments. A replication segment is a forwarding instruction for a candidate path which is downloaded to the Root, transit nodes and the leaves.

This document describes a simple and efficient mechanism that can be used to detect data plane failures in P2MP Policy Candidate Paths (CPs) and Path Instances (PIs).

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."

This Internet-Draft will expire on 23 January 2025.

1. Introduction

Each P2MP Policy can have multiple Candidate Paths (CP)s. The CP with highest preference is the active CP while all other CPs are the backup CPs. A CP can have multiple PIs to allow global optimization of the CP via Make Before Break procedures between the active PI and the newly setup and optimized PI.

It is desirable to test the end to end connectivity of a CP, whether it is the active CP or a backup CP and all the CP's PIs. This document describes a mechanism that can be used to detect data plane failures in P2MP Policy CP and its associate Path Instances (PI).

This draft is only for replication SIDs that use MPLS encap for their forwarding and not SRv6. It reuses most of the concepts in [RFC6425]

2. Conventions used in this document

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here.

3. Motivation

A P2MP Policy and its corresponding Replication Segments are usually setup via a controller, the root and the leaves are discovered as per [draft-ietf-pim-sr-p2mp-policy-09]. The tree is calculated from the root to the leaves. There is no underlay protocol to signal the P2MP Policy from the root to the Leaf routers, as such when a P2MP tree fails to deliver user traffic, the failure can be difficult to pin point without a ping/traceroute mechanism to isolate the fault in the P2MP tree. The P2MP Policy ping/traceroute can be utilize to detect faults on the path of the tree and its associated replication segments [RFC9524]. These tools can be used to periodically ping the leaves to ensure connectivity. If the ping fails, trace route can be initiated to determine where the failure lies. The ping/traceroute can be initiated from the node that initiates the P2MP policy.

3.1. MPLS P2MP Policy Ping and Traceroute

Ping/Traceroute packets are forwarded on the P2MP Policy, on a specific CP and its PIs toward the leaf routers. They are replicated at the replication point based on the replication segment forwarding information on the corresponding node. This draft only addresses the replication segments that use MPLS encap, future drafts will address replication segments using SRv6 encap. The packets are processed accordingly when their TTL expires or when the egress router (leaf) is reached. The appropriate respond is sent back to the root as per procedures in [RFC6425]

[RFC6425] scope is fault detection and isolation for P2MP MPLS LSPs. [RFC6425] extends the techniques described in [RFC8029] such that they may be applied to P2MP MPLS LSPs. [RFC6425] stresses the reuse of existing LSP ping mechanisms used for P2P LSPs, and applies them to P2MP MPLS LSPs in order to simplify implementation and network operation.

The [RFC6425] procedures for fault detection of a P2MP MPLS LSP are common for all P2MP MPLS protocols, including P2MP RSVP-TE and Multicast LDP and now P2MP SR Policy. There are minor differences pointed out in [RFC6425] with regards to P2MP RSVP-TE and Multicast LDP which this draft will specifically address for SR P2MP Policy, these minor differences are as follow:

  1. Including Egress Address P2MP Responder Sub-TLVs, which can not be included for Multicast LDP as per section 3.2.1 of [RFC6425]. In Multicast LDP, there is no way for upstream LSRs to know the identity of the downstream leaf nodes. This is also true for P2MP LSPs of P2MP SR Policy as most transit routers are programmed via a PCE and have no knowledge of the leaf nodes. The only node that might have knowledge of the leaf nodes is the Root where the P2MP SR Policy is programmed. Hence these sub-TLVs SHOULD NOT be used with an echo request carrying a P2MP Policy MPLS Candidate Path FEC.

  2. End of Processing for Traceroutes, for Multicast LDP LSPs, the initiating LSR might not always know about all the egress nodes unlike P2MP RSVP-TE. For P2MP SR Policy the Root of the tree can be aware of the all the egress nodes in the case of PCC initiate P2MP SR Policy and optionally it MAY be aware of the all the egress nodes if the P2MP SR Policy is PCE initiated. Therefore P2MP SR Policy SHOULD follow the recommendation of section 4.3.1 of [RFC6425] depending on if the root is aware of the all the egress nodes or not. As an example for PCC initiate P2MP SR Policy the root can learn the identities of egress nodes via the Next Generation MVPN procedures and BGP as per [RFC6514], but with PCE initiated P2MP SR Policy, the egress nodes may not be downloaded to the root by the PCE, as this is optional and implementation specific.

  3. Another major difference between P2MP RSVP-TE and Multicast LDP in [RFC6425] is section 3.1 for identifying the LSP under test. Each protocol has its own identifier. This draft defines a new Target FEC Stack TLV for P2MP SR Policy to identify the its CPs and PIs.

Beside the major differences explained above, P2MP SR Policy should follow [RFC6425] common procedures for P2MP MPLS LSPs. This draft also reuses the same destination UDP port as [RFC8029]

The implementation should take into account that there can be many CPs under the P2MP Policy and the implementation should allow each CP and its corresponding PI to be tested via Ping and Traceroute. The Ping and Traceroute packet is forwarded via that specific CP and its PI and its corresponding replication segments. On downstream nodes when the ping and trace route is received, the node should process the packet and generate a response even if the CP and its PI is not the active path.

Two replication segments can be connected via a unicast SR domain. In this scenario the SR tunnel labels need to be programmed with the right TTL depending on the which type of hierarchical MPLS TTL mode is used. As an example pipe vs uniform mode. When in SR domain the P2MP Tree PING and Traceroute will be processed on the two connecting replication segments based on the replication SID and its TTL. As such the SR domain will act as a single hop on the replication SID and the replication SID TTL is subtracted by one before the unicast SR SIDs are pushed on the replication SID. To detect failure in SR domain is beyond the scope of this draft.

3.2. Packet format and new TLVs

The packet format used is as per [RFC8029] section 3. Some new TLVs and sub-TLVs are required to support the new functionality. They are described in the following sections.

3.2.1. Identifying a P2MP Policy

[RFC8029] defines a simple and efficient mechanism to detect data-plane failures in Multiprotocol Label Switching (MPLS) Label Switched Paths (LSPs). In order to identify the correct replication segment for the CP and its PI, the echo request message MUST carry a Target FEC Stack TLV for the Candidate path and the Path instance that is under test. This draft defines a new sub-TLV: P2MP policy MPLS Candidate Path sub-TLV. The new sub-TLV is described in the following sections.

Sub-Type       Length            Value Field
--------       ------            -----------
    41        Variable          P2MP Policy MPLS Candidate Path

3.2.1.1. P2MP Policy CP FEC Stack Sub-TLVs

The format of the P2MP Policy MPLS Candidate Path sub-TLV value field is specified in the following figure. The value fields are taken from the definitions of the P2MP Policy section 2 of [draft-ietf-pim-sr-p2mp-policy-09]

    0                   1                   2                   3
    0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
   |        Address Family         | Address Length|   Reserved    |
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
   |                                                               |
   ~                            Root                               ~
   |                                                               |
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
   |                         Tree-ID                               |
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
   |                        Instance-ID                            |
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+

3.3. Limiting the Scope of Response

As per [RFC6425] section 3.2 Four sub-TLVs are used for the inclusion in the P2MP Responder Identifier TLV carried on the echo request message.

The Sub-TLVs for IPv4 and IPv6 egress address P2MP responder is in par with [RFC6425] section 3.2.1

The Sub-TLVs for IPv4 and IPv6 node address P2MP responder is in par with [RFC6425] section 3.2.2

4. Implementation Status

Note to the RFC Editor: please remove this section before publication. This section records the status of known implementations of the protocol defined by this specification at the time of posting of this Internet-Draft, and is based on a proposal described in RFC7942 . The description of implementations in this section is intended to assist the IETF in its decision processes in progressing drafts to RFCs. Please note that the listing of any individual implementation here does not imply endorsement by the IETF. Fu, thermore, no effort has been spent to verify the information presented here that was supplied by IETF contributors. This is not intended as, and must not be construed to be, a catalog of available implementations or their features. Readers are advised to note that other implementations may exist. According to RFC7942, "this will allow reviewers and working groups to assign due consideration to documents that have the benefit of running code, which may serve as evidence of valuable experimentation and feedback that have made the implemented protocols more mature. It is up to the individual working groups to use this information as they see fit".

4.1. Nokia Implementation

Nokia has implemented [draft-ietf-pim-sr-p2mp-policy-09] and [RFC9524]. In addition, Nokia has implemented P2MP policy ping as defined in this draft to verify the end to end connectivity of a P2MP tree in segment routing domain. The implementation supports SR-MPLS encapsulation and has all the MUST and SHOULD clause in this draft. The implementation is at general availability maturity and is compliant with the latest version of the draft. The documentation for implementation can be found at Nokia help and the point of contact is hooman.bidgoli@nokia.com.

5. IANA Consideration

IANA has assigned the following code points for sub-type values to the following sub-TLVs under TLV type 1 (Target FEC Stack) from the "Multi-Protocol Label Switching (MPLS) Label Switched Paths (LSPs) Ping Parameters" registry, "TLVs and sub-TLVs" sub-registry. This sub-type value is assigned from the standards Action of range 0-16383 for TLV type 1 (Target FEC Stack)

41: P2MP Policy MPLS Candidate Path

6. Security Considerations

Overall, the security needs for P2MP policy ping is same as [RFC8029]. The P2MP policy ping is susceptible to the same three attack vectors as explained in RFC8029 section 5. The same procedures and recommendations explained in [RFC8029] section 5 should be taken and implemented to mitigate these attack vectors for P2MP policy Ping as well.

7. Acknowledgments

8. Normative References

[draft-ietf-pim-sr-p2mp-policy-09]
"D. Yoyer, C. Filsfils, R.Prekh, H.bidgoli, Z. Zhang, "draft-ietf-pim-sr-p2mp-policy"", .
[IANA-AF]
"IANA Assigned Port Numbers, "http://www.iana.org/assignments/address-family-numbers"".
[RFC2119]
"S. Brandner, "Key words for use in RFCs to Indicate Requirement Levels"", .
[RFC6425]
"S. Saxena, G. Swallow, Z. Ali, A. Farrel, S. Yasukawa, T.Nadeau "Detecting Data-Plane Failures in Point-to-Multipoint MPLS"", .
[RFC6514]
"R.Aggarwal, E. Rosen, T. Morin, Y. Rekhter "BGP Encodings and Procedures for Multicast in MPLS/BGP IP VPNs"", .
[RFC8029]
"K. Kompella, G. Swallow, C. Pgnataro, N. kumar, S. Aldrin M. Chen, "Detecting Multiprotocol Label Switched (MPLS) Data-Plane Failures.", .
[RFC8174]
"B. Leiba, "ambiguity of Uppercase vs Lowercase in RFC 2119 Key Words"", .
[RFC9524]
"D. Voyer, C. Filsfils, R. Parekh, H. Bidgoli, Z. Zhang, "Segment Routing Replication for Multipoint Service Delivery"", .

Authors' Addresses

Hooman Bidgoli (editor)
Nokia
Ottawa
Canada
Daniel Voyer
Bell Canada
Montreal
Canada
Rishabh Parekh
Cisco System
San Jose,
United States of America
Zhaohui Zhang
Juniper Networks
Boston,
United States of America