Diameter Overload Rate Control
draft-donovan-dime-doc-rate-control-02
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Steve Donovan , Eric Noel | ||
| Last updated | 2014-11-10 | ||
| Replaced by | draft-ietf-dime-doic-rate-control | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-dime-doic-rate-control | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This specification documents an extension to the Diameter Overload Indication Conveyance (DOIC) base solution. This extension adds a new overload control abatement algorithm. This abatement algorithm allows for a DOIC reporting node to specify a maximum rate at which a DOIC reacting node sends Diameter requests sent to the DOIC reporting node. Requirements
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)