Transferring MIB Work from IETF Ethernet Interfaces and Hub MIB WG to IEEE 802.3 WG
draft-taylor-opsawg-mibs-to-ieee80231-01
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Tom Taylor , Dan Romascanu | ||
Last updated | 2015-01-12 (Latest revision 2014-07-21) | ||
Replaced by | draft-ietf-opsawg-mibs-to-ieee80231 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-opsawg-mibs-to-ieee80231 | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document records the transfer of ownership of the Ethernet- related MIB modules DOT3-OAM-MIB, SNMP-REPEATER-MIB, POWER-ETHERNET- MIB, DOT3-EPON-MIB, EtherLike-MIB, EFM-CU-MIB, ETHER-WIS and MAU-MIB from the IETF to the IEEE 802.3 Working Group. This document also describes the procedures associated with the transfer, relying heavily on RFC 4663 (which records an earlier transfer to the IEEE 802.1 Working Group) as the primary source.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)