INTERNET-DRAFT S. Legg draft-legg-ldap-admin-03.txt eB2Bcom Intended Category: Standards Track September 3, 2007 Lightweight Directory Access Protocol (LDAP): Directory Administrative Model Copyright (C) The IETF Trust (2007). Status of This Memo By submitting this Internet-draft, each author represents that any applicable patent or other IPR claims of which he or she is aware have been or will be disclosed, and any of which he or she becomes aware will be disclosed, in accordance with Section 6 of BCP 79. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF), its areas, and its working groups. Note that other groups may also distribute working documents as Internet-Drafts. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress". The list of current Internet-Drafts can be accessed at http://www.ietf.org/1id-abstracts.html The list of Internet-Draft Shadow Directories can be accessed at http://www.ietf.org/shadow.html Comments should be sent to the author. This Internet-Draft expires on 3 March 2008. Abstract This document adapts the X.500 directory administrative model for use by the Lightweight Directory Access Protocol (LDAP). The administrative model partitions the Directory Information Tree (DIT) for various aspects of directory data administration, e.g., subschema, access control, and collective attributes. The generic framework that applies to every aspect of administration is described in this document. The definitions that apply for a specific aspect of administration, e.g., access control administration, are described Legg Expires 3 March 2008 [Page 1]
INTERNET-DRAFT Directory Administrative Model September 3, 2007 in other documents. Table of Contents 1. Introduction ....................................................2 2. Conventions .....................................................2 3. Administrative Areas ............................................2 4. Autonomous Administrative Areas .................................3 5. Specific Administrative Areas ...................................3 6. Inner Administrative Areas ......................................4 7. Administrative Entries ..........................................4 8. Security Considerations .........................................5 9. Acknowledgements ................................................5 10. References .....................................................5 10.1. Normative References ......................................5 10.2. Informative References ....................................5 1. Introduction This document adapts the X.500 directory administrative model [X.501] for use by the Lightweight Directory Access Protocol (LDAP) [LDAP]. The administrative model partitions the Directory Information Tree (DIT) for various aspects of directory data administration, e.g., subschema, access control, and collective attributes. This document provides the definitions for the generic parts of the administrative model that apply to every aspect of directory data administration. Sections 3 to 7, in conjunction with [SUBENTRY], describe the means by which administrative authority is aportioned and exercised in the DIT. Aspects of administration that conform to the administrative model described in this document, e.g., access control administration [ACA] and collective attribute administration [COLLECT], are detailed elsewhere. This document is derived from, and duplicates substantial portions of, Sections 4 and 8 of X.501 [X.501]. 2. Conventions The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14, RFC 2119 [BCP14]. 3. Administrative Areas Legg Expires 3 March 2008 [Page 2]
INTERNET-DRAFT Directory Administrative Model September 3, 2007 An administrative area is a subtree of the DIT considered from the perspective of administration. The root entry of the subtree is an administrative point. An administrative point is represented by an entry holding an administrativeRole attribute [SUBENTRY]. The values of this attribute identify the kind of administrative point. 4. Autonomous Administrative Areas The DIT may be partitioned into one or more non-overlapping subtrees termed autonomous administrative areas. It is expected that the entries in an autonomous administrative area are all administered by the same administrative authority. An administrative authority may be responsible for several autonomous administrative areas in separated parts of the DIT but it SHOULD NOT arbitrarily partition the collection of entries under its control into autonomous administrative areas (thus creating adjacent autonomous areas administered by the same authority). The root entry of an autonomous administrative area's subtree is called an autonomous administrative point. An autonomous administrative area extends from its autonomous administrative point downwards until another autonomous administrative point is encountered, at which point another autonomous administrative area begins. 5. Specific Administrative Areas Entries in an administrative area may be considered in terms of a specific administrative function. When viewed in this context, an administrative area is termed a specific administrative area. Examples of specific administrative areas are subschema specific administrative areas, access control specific areas, and collective attribute specific areas. An autonomous administrative area may be considered as implicitly defining a single specific administrative area for each specific aspect of administration. In this case, there is a precise correspondence between each such specific administrative area and the autonomous administrative area. Alternatively, for each specific aspect of administration, the autonomous administrative area may be partitioned into non-overlapping specific administrative areas. If so partitioned for a particular aspect of administration, each entry of the autonomous administrative area is contained in one and Legg Expires 3 March 2008 [Page 3]
INTERNET-DRAFT Directory Administrative Model September 3, 2007 only one specific administrative area for that aspect, i.e., specific administrative areas do not overlap. The root entry of a specific administrative area's subtree is called a specific administrative point. A specific administrative area extends from its specific administrative point downwards until another specific administrative point of the same administrative aspect is encountered, at which point another specific administrative area begins. Specific administrative areas are always bounded by the autonomous administrative area they partition. Where an autonomous administrative area is not partitioned for a specific aspect of administration, the specific administrative area for that aspect coincides with the autonomous administrative area. In this case, the autonomous administrative point is also the specific administrative point for this aspect of administration. A particular administrative point may be the root of an autonomous administrative area and may be the root of one or more specific administrative areas for different aspects of administration. It is not necessary for an administrative point to represent each specific aspect of administrative authority. For example, there might be an administrative point, subordinate to the root of the autonomous administrative area, that is used for access control purposes only. 6. Inner Administrative Areas For some aspects of administration, e.g., access control or collective attributes, inner administrative areas may be defined within the specific administrative areas, to allow a limited form of delegation, or for administrative or operational convenience. An inner administrative area may be nested within another inner administrative area. The rules for nested inner areas are defined as part of the definition of the specific administrative aspect for which they are allowed. The root entry of an inner administrative area's subtree is called an inner administrative point. An inner administrative area (within a specific administrative area) extends from its inner administrative point downwards until a specific administrative point of the same administrative aspect is encountered. An inner administrative area is bounded by the specific administrative area within which it is defined. 7. Administrative Entries Legg Expires 3 March 2008 [Page 4]
INTERNET-DRAFT Directory Administrative Model September 3, 2007 An entry located at an administrative point is an administrative entry. Administrative entries MAY have subentries [SUBENTRY] as immediate subordinates. The administrative entry and its associated subentries are used to control the entries encompassed by the associated administrative area. Where inner administrative areas are used, the scopes of these areas may overlap. Therefore, for each specific aspect of administrative authority, a definition is required of the method of combination of administrative information when it is possible for entries to be included in more than one subtree or subtree refinement associated with an inner area defined for that aspect. 8. Security Considerations This document defines a generic framework for employing policy of various kinds, e.g., access controls, to entries in the DIT. Such policy can only be correctly enforced at a directory server holding a replica of a portion of the DIT if the administrative entries for administrative areas that overlap the portion of the DIT being replicated, and the subentries of those administrative entries relevant to any aspect of policy that is required to be enforced at the replica, are included in the replicated information. Administrative entries and subentries SHOULD be protected from unauthorized examination or changes by appropriate access controls. 9. Acknowledgements This document is derived from, and duplicates substantial portions of, Sections 4 and 8 of X.501 [X.501]. 10. References 10.1. Normative References [BCP14] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. [SUBENTRY] Zeilenga, K. and S. Legg, "Subentries in the Lightweight Directory Access Protocol (LDAP)", RFC 3672, December 2003. [LDAP] Zeilenga, K., Ed., "Lightweight Directory Access Protocol (LDAP): Technical Specification Road Map", RFC 4510, June 2006. 10.2. Informative References Legg Expires 3 March 2008 [Page 5]
INTERNET-DRAFT Directory Administrative Model September 3, 2007 [COLLECT] Zeilenga, K., "Collective Attributes in the Lightweight Directory Access Protocol (LDAP)", RFC 3671, December 2003. [ACA] Legg, S., "Lightweight Directory Access Protocol (LDAP): Access Control Administration", draft-legg-ldap-acm-admin-xx.txt, a work in progress, June 2004. [X.501] ITU-T Recommendation X.501 (08/05) | ISO/IEC 9594-2:2005, Information technology - Open Systems Interconnection - The Directory: Models. IANA Considerations This document has no actions for IANA. Author's Address Dr. Steven Legg eB2Bcom Suite 1, 85-87 Charles Street Kew, Victoria 3101 AUSTRALIA Phone: +61 3 9851 8630 Fax: +61 3 9851 8601 EMail: steven.legg@eb2bcom.com Full Copyright Statement Copyright (C) The IETF Trust (2007). This document is subject to the rights, licenses and restrictions contained in BCP 78, and except as set forth therein, the authors retain all their rights. This document and the information contained herein are provided on an "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY, THE IETF TRUST AND THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Intellectual Property The IETF takes no position regarding the validity or scope of any Legg Expires 3 March 2008 [Page 6]
INTERNET-DRAFT Directory Administrative Model September 3, 2007 Intellectual Property Rights or other rights that might be claimed to pertain to the implementation or use of the technology described in this document or the extent to which any license under such rights might or might not be available; nor does it represent that it has made any independent effort to identify any such rights. Information on the procedures with respect to rights in RFC documents can be found in BCP 78 and BCP 79. Copies of IPR disclosures made to the IETF Secretariat and any assurances of licenses to be made available, or the result of an attempt made to obtain a general license or permission for the use of such proprietary rights by implementers or users of this specification can be obtained from the IETF on-line IPR repository at http://www.ietf.org/ipr. The IETF invites any interested party to bring to its attention any copyrights, patents or patent applications, or other proprietary rights that may cover technology that may be required to implement this standard. Please address the information to the IETF at ietf-ipr@ietf.org. Note to the RFC Editor: the remainder of this document is to be removed before final publication. Changes in Draft 00 This document reproduces Section 4 from draft-legg-ldap-acm-admin-00.txt as a standalone document. All changes made are purely editorial. No technical changes have been introduced. Changes in Draft 01 RFC 3377 replaces RFC 2251 as the reference for LDAP. Changes in Draft 02 The document has been reformatted in line with current practice. Changes in Draft 03 RFC 4510 replaces RFC 3377 as the reference for LDAP. Legg Expires 3 March 2008 [Page 7]