IPv6 Maintenance L. Colitti
Internet-Draft E. Kline
Intended status: Standards Track J. Linkova
Expires: January 21, 2019 Google
July 20, 2018
Discovering PREF64 in Router Advertisements
draft-pref64folks-6man-ra-pref64-01
Abstract
This document specifies a Router Advertisement option to configure
the NAT64 prefix.
Status of This Memo
This Internet-Draft is submitted in full conformance with the
provisions of BCP 78 and BCP 79.
Internet-Drafts are working documents of the Internet Engineering
Task Force (IETF). Note that other groups may also distribute
working documents as Internet-Drafts. The list of current Internet-
Drafts is at https://datatracker.ietf.org/drafts/current/.
Internet-Drafts are draft documents valid for a maximum of six months
and may be updated, replaced, or obsoleted by other documents at any
time. It is inappropriate to use Internet-Drafts as reference
material or to cite them other than as "work in progress."
This Internet-Draft will expire on January 21, 2019.
Copyright Notice
Copyright (c) 2018 IETF Trust and the persons identified as the
document authors. All rights reserved.
This document is subject to BCP 78 and the IETF Trust's Legal
Provisions Relating to IETF Documents
(https://trustee.ietf.org/license-info) in effect on the date of
publication of this document. Please review these documents
carefully, as they describe your rights and restrictions with respect
to this document. Code Components extracted from this document must
include Simplified BSD License text as described in Section 4.e of
the Trust Legal Provisions and are provided without warranty as
described in the Simplified BSD License.
Colitti, et al. Expires January 21, 2019 [Page 1]
Internet-Draft Discovering PREF64 in Router Advertisements July 2018
Table of Contents
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . 2
1.1. Requirements Language . . . . . . . . . . . . . . . . . . 2
2. Why include the NAT64 prefix in Router Advertisements . . . . 2
3. Semantics . . . . . . . . . . . . . . . . . . . . . . . . . . 3
4. Option format . . . . . . . . . . . . . . . . . . . . . . . . 3
5. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 4
6. Security Considerations . . . . . . . . . . . . . . . . . . . 5
7. References . . . . . . . . . . . . . . . . . . . . . . . . . 5
7.1. Normative References . . . . . . . . . . . . . . . . . . 5
7.2. Informative References . . . . . . . . . . . . . . . . . 5
7.3. URIs . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Authors' Addresses . . . . . . . . . . . . . . . . . . . . . . . 6
1. Introduction
NAT64 [RFC6146] with DNS64 [RFC6147] is a widely-deployed mechanism
to provide IPv4 access on IPv6-only networks. In order to support
functions such as local validation of DNSSEC [RFC4033] responses,
464xlat [RFC6877], and local IPv4 address synthesis [RFC8305], the
host must be aware of the NAT64 prefix in use by the network. This
document specifies a Router Advertisement [RFC4861] option to
communicate the NAT64 prefix to hosts.
1.1. Requirements Language
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in RFC 2119 [RFC2119].
2. Why include the NAT64 prefix in Router Advertisements
Fate sharing. NAT64 requires a routing to be configured. IPv6
routing configuration requires receiving an IPv6 Router Advertisement
[RFC4861]. Compared to currently-deployed NAT64 prefix discovery
methods such as [RFC7050], including the NAT64 prefix in the Router
Advertisement minimizes the number of packets required to configure a
host. This speeds up the process of connecting to a network that
supports NAT64/DNS64, and simplifies host implementation by removing
the possibility that the a can have an incomplete layer 3
configuration (e.g., IPv6 addresses and prefixes, but no NAT64
prefix).
Deployability. All IPv6 hosts and networks are required to support
[RFC4861]. Other options such as [RFC7225] require implementing
other protocols.
Colitti, et al. Expires January 21, 2019 [Page 2]
Internet-Draft Discovering PREF64 in Router Advertisements July 2018
3. Semantics
This option specifies exactly one NAT64 prefix for all IPv4
destinations. If the network operator desires to route different
parts of the IPv4 address space to different NAT64 devices, this can
be accomplished by routing more specifics of the NAT64 prefix to
those devices. For example, if the operator would like to route
10.0.0.0/8 through NAT64 device A and the rest of the IPv4 space
through NAT64 device B, and the operator's NAT64 prefix is
2001:db8:a:b::/96, then the operator can route
2001:db8:a:b::a00:0/104 to NAT64 A and 2001:db8:a:b::/64 to NAT64 B.
This option may appear more than once in a Router Advertisement.
Host behaviour with regards to synthesizing IPv6 addresses from IPv4
addresses SHOULD follow the recommendations given in Section 5.1 of
[RFC7050], limited to the NAT64 prefixes that have non-zero lifetime.
In a network that provides both IPv4 and NAT64, it may be desirable
for certain IPv4 addresses not to be translated. An example might be
private address ranges that are local to the network and should not
be reached through the NAT64. This type of configuration cannot be
conveyed to hosts using this option, or through other NAT64 prefix
provisioning mechanisms such as [RFC7050] or [RFC7225]. This problem
does not apply in IPv6-only networks, because in such networks, the
host does not have an IPv4 address and cannot reach any IPv4
destinations without the NAT64.
For simplicity, this option only supports a NAT64 prefix length of 96
bits, as this is by the most common configuration used by hosts.
Networks using one of the other prefix lengths supported in
([RFC6052]) can use other mechanisms such as [RFC7050] or [RFC7225].
If different prefix lengths become common, another RA option could be
created to configure them.
4. Option format
Colitti, et al. Expires January 21, 2019 [Page 3]
Internet-Draft Discovering PREF64 in Router Advertisements July 2018
0 1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Type | Length | Lifetime |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| |
+ Prefix +
| |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
Figure 1: NAT64 Prefix Option Format
Fields:
Type 8-bit identifier of the RDNSS option type as assigned by
IANA: TBD
Length 8-bit unsigned integer. The length of the option (including
the Type and Length fields) is in units of 8 octets. The
sender MUST set the Length to 2. A host MUST ignore the
NAT64 prefix option if the length field value is 1. If the
Length field value exceeds 2, the host MUST utilize the
first 16 octets and ignore the rest of the option.
Lifetime 16-bit unsigned integer. The maximum time in seconds over
which this NAT64 prefix MAY be used. The value of Lifetime
SHOULD by default be set to lesser of 3 x MaxRtrAdvInterval
or 65535 seconds. A value of zero means that the prefix
MUST no longer be used.
Prefix The highest 96-bits of the NAT64 prefix.
5. IANA Considerations
The IANA is requested to assign a new IPv6 Neighbor Discovery Option
type for the PREF64 option defined in this document.
+---------------+-------+
| Option Name | Type |
+---------------+-------+
| PREF64 option | (TBD) |
+---------------+-------+
Table 1
The IANA registry for these options is:
https://www.iana.org/assignments/icmpv6-parameters [1]
Colitti, et al. Expires January 21, 2019 [Page 4]
Internet-Draft Discovering PREF64 in Router Advertisements July 2018
6. Security Considerations
Because Router Advertisements are required in all IPv6 configuration
scenarios, on IPv6-only networks, Router Advertisements must already
be secured, e.g., by deploying RA guard [RFC6105]. Providing all
configuration in Router Advertisements increases security by ensuring
that no other protocols can be abused by malicious attackers to
provide hosts with invalid configuration.
The security measures that must already be in place to ensure that
Router Advertisements are only received from legitimate sources
eliminate the problem of NAT64 prefix validation described in section
3.1 of [RFC7050].
7. References
7.1. Normative References
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC 2119,
DOI 10.17487/RFC2119, March 1997,
<https://www.rfc-editor.org/info/rfc2119>.
[RFC6052] Bao, C., Huitema, C., Bagnulo, M., Boucadair, M., and X.
Li, "IPv6 Addressing of IPv4/IPv6 Translators", RFC 6052,
DOI 10.17487/RFC6052, October 2010,
<https://www.rfc-editor.org/info/rfc6052>.
7.2. Informative References
[RFC4033] Arends, R., Austein, R., Larson, M., Massey, D., and S.
Rose, "DNS Security Introduction and Requirements",
RFC 4033, DOI 10.17487/RFC4033, March 2005,
<https://www.rfc-editor.org/info/rfc4033>.
[RFC4861] Narten, T., Nordmark, E., Simpson, W., and H. Soliman,
"Neighbor Discovery for IP version 6 (IPv6)", RFC 4861,
DOI 10.17487/RFC4861, September 2007,
<https://www.rfc-editor.org/info/rfc4861>.
[RFC6105] Levy-Abegnoli, E., Van de Velde, G., Popoviciu, C., and J.
Mohacsi, "IPv6 Router Advertisement Guard", RFC 6105,
DOI 10.17487/RFC6105, February 2011,
<https://www.rfc-editor.org/info/rfc6105>.
Colitti, et al. Expires January 21, 2019 [Page 5]
Internet-Draft Discovering PREF64 in Router Advertisements July 2018
[RFC6146] Bagnulo, M., Matthews, P., and I. van Beijnum, "Stateful
NAT64: Network Address and Protocol Translation from IPv6
Clients to IPv4 Servers", RFC 6146, DOI 10.17487/RFC6146,
April 2011, <https://www.rfc-editor.org/info/rfc6146>.
[RFC6147] Bagnulo, M., Sullivan, A., Matthews, P., and I. van
Beijnum, "DNS64: DNS Extensions for Network Address
Translation from IPv6 Clients to IPv4 Servers", RFC 6147,
DOI 10.17487/RFC6147, April 2011,
<https://www.rfc-editor.org/info/rfc6147>.
[RFC6877] Mawatari, M., Kawashima, M., and C. Byrne, "464XLAT:
Combination of Stateful and Stateless Translation",
RFC 6877, DOI 10.17487/RFC6877, April 2013,
<https://www.rfc-editor.org/info/rfc6877>.
[RFC7050] Savolainen, T., Korhonen, J., and D. Wing, "Discovery of
the IPv6 Prefix Used for IPv6 Address Synthesis",
RFC 7050, DOI 10.17487/RFC7050, November 2013,
<https://www.rfc-editor.org/info/rfc7050>.
[RFC7225] Boucadair, M., "Discovering NAT64 IPv6 Prefixes Using the
Port Control Protocol (PCP)", RFC 7225,
DOI 10.17487/RFC7225, May 2014,
<https://www.rfc-editor.org/info/rfc7225>.
[RFC8305] Schinazi, D. and T. Pauly, "Happy Eyeballs Version 2:
Better Connectivity Using Concurrency", RFC 8305,
DOI 10.17487/RFC8305, December 2017,
<https://www.rfc-editor.org/info/rfc8305>.
7.3. URIs
[1] https://www.iana.org/assignments/icmpv6-parameters
Authors' Addresses
Lorenzo Colitti
Google
Roppongi 6-10-1
Minato, Tokyo 106-6126
JP
Email: lorenzo@google.com
Colitti, et al. Expires January 21, 2019 [Page 6]
Internet-Draft Discovering PREF64 in Router Advertisements July 2018
Erik Kline
Google
Roppongi 6-10-1
Minato, Tokyo 106-6126
JP
Email: ek@google.com
Jen Linkova
Google
1 Darling Island Rd
Pyrmont, NSW 2009
AU
Email: furry@google.com
Colitti, et al. Expires January 21, 2019 [Page 7]