Internet Engineering Task Force T. Fossati
Internet-Draft KoanLogic
Intended status: Standards Track April 8, 2012
Expires: October 10, 2012
Multipart Media Type Encoding for CoAP
draft-fossati-core-multipart-ct-00
Abstract
This memo defines a new media type encoding that can be used to
combine several different media types into a single CoAP message-
body.
Status of this Memo
This Internet-Draft is submitted in full conformance with the
provisions of BCP 78 and BCP 79.
Internet-Drafts are working documents of the Internet Engineering
Task Force (IETF). Note that other groups may also distribute
working documents as Internet-Drafts. The list of current Internet-
Drafts is at http://datatracker.ietf.org/drafts/current/.
Internet-Drafts are draft documents valid for a maximum of six months
and may be updated, replaced, or obsoleted by other documents at any
time. It is inappropriate to use Internet-Drafts as reference
material or to cite them other than as "work in progress."
This Internet-Draft will expire on October 10, 2012.
Copyright Notice
Copyright (c) 2012 IETF Trust and the persons identified as the
document authors. All rights reserved.
This document is subject to BCP 78 and the IETF Trust's Legal
Provisions Relating to IETF Documents
(http://trustee.ietf.org/license-info) in effect on the date of
publication of this document. Please review these documents
carefully, as they describe your rights and restrictions with respect
to this document. Code Components extracted from this document must
include Simplified BSD License text as described in Section 4.e of
the Trust Legal Provisions and are provided without warranty as
described in the Simplified BSD License.
Fossati Expires October 10, 2012 [Page 1]
Internet-Draft Multipart Media Type Encoding for CoAP April 2012
Table of Contents
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . 3
1.1. Requirements Language . . . . . . . . . . . . . . . . . . . 3
2. Multipart Media Type Encoding . . . . . . . . . . . . . . . . . 3
3. Length Encoding . . . . . . . . . . . . . . . . . . . . . . . . 3
3.1. Short . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
3.2. Extended . . . . . . . . . . . . . . . . . . . . . . . . . 4
3.3. Constraints . . . . . . . . . . . . . . . . . . . . . . . . 4
3.4. Examples . . . . . . . . . . . . . . . . . . . . . . . . . 4
4. IANA Considerations . . . . . . . . . . . . . . . . . . . . . . 5
5. Security Considerations . . . . . . . . . . . . . . . . . . . . 5
6. Normative References . . . . . . . . . . . . . . . . . . . . . 5
Author's Address . . . . . . . . . . . . . . . . . . . . . . . . . 5
Fossati Expires October 10, 2012 [Page 2]
Internet-Draft Multipart Media Type Encoding for CoAP April 2012
1. Introduction
This memo defines a new media type encoding that can be used to
combine several different media types into a single CoAP message-
body.
1.1. Requirements Language
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in [RFC2119].
2. Multipart Media Type Encoding
Multipart encoding uses multiple adjacent frames each of which
represents a single media. Every frame can further be broken in
three logical pieces: the type of the framed media (T), its length in
bytes (L), and the media payload itself (V) as depicted in the
following figure.
,------------------ multi part -----------------.
+------+------+------+ +------+------+------+
| T[0] | L[0] | V[0] | ... | T[n] | L[n] | V[n] |
+------+------+------+ +------+------+------+
`------ part 0 ------' `------ part n ------'
The semantics associated to the TLV atoms is as follows:
T: is one of the numeric media type identifiers defined in the CoAP
Media Type registry (Section 11.3 of [I-D.ietf-core-coap]), and is
encoded as a 16-bit uint (Appendix A of [I-D.ietf-core-coap]).
L: is the lentgh in bytes of the following V frame, and has two
possible encodings: short or extended (see Section 3). It
determines the offset of the next part, or the end of the
multipart representation when applied to the last frame.
V: is the media, encoded as implied by the preceeding T field.
3. Length Encoding
Two different encodings are defined for the L value: short for parts
where length(V) measured in bytes is in range [0, 32767]; extended
for parts with length(V) in range (32767, 2^127-1].
Fossati Expires October 10, 2012 [Page 3]
Internet-Draft Multipart Media Type Encoding for CoAP April 2012
3.1. Short
The short format uses a fixed 16-bit uint with the most significant
bit set to '0'. The remaining 15 bits encode a length(V) value up to
32767 bytes.
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
|0| 0-32767 |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
3.2. Extended
The extended format uses a fixed 8-bit uint with the most significant
bit set to '1'. The remaining 7 bits encode the number of bytes
needed to uint-encode the length(V) bytes.
0 1 2 3 4 5 6 7
+-+-+-+-+-+-+-+-+------/ /------+
|1| 0-127 | 0-(2^127-1) |
+-+-+-+-+-+-+-+-+------/ /------+
3.3. Constraints
The most compact encoding MUST be used, i.e.:
1. always use short when length(V) < 32768;
2. never zero-pad when using extended.
3.4. Examples
A length of 32767 bytes would use short encoding:
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
|0|1 1 1 1 1 1 1 1 1 1 1 1 1 1 1|
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
S len=32767
A length of 32768 bytes would use extended encoding with lenght of
lenght 2:
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
|1|0 0 0 0 0 1 0|1 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0|
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
E lenlen=2 len=32768
Fossati Expires October 10, 2012 [Page 4]
Internet-Draft Multipart Media Type Encoding for CoAP April 2012
4. IANA Considerations
The following entry is added to the CoAP Media Type registry:
.--------------------------------.
| Number | Name | Reference |
:--------:-----------:-----------:
| n | Multipart | RFC XXXX |
`--------------------------------'
When used as the payload in a CoAP message, one Content-Type option
MUST be present and set to n.
5. Security Considerations
The extended encoding may trigger insanely huge buffer allocations on
the receiving party. Receivers of multipart media SHOULD put a cap
on the maximum allowed size of the whole Multipart. A CoAP server
MAY respond with a 4.13 (Request Entity Too Large) status code to
such requests, and refuse to proceed further (e.g. processing more
blocks).
A CoAP client can't tell if a 4.15 status code applies to the whole
Multipart or just to one of its parts. An attacker may leverage on
this ambiguity to craft application specific attacks (e.g. cause
downgraded behavior). Applications built on top of Multipart need to
handle such eventuality in a safe way.
6. Normative References
[I-D.ietf-core-coap]
Frank, B., Bormann, C., Hartke, K., and Z. Shelby,
"Constrained Application Protocol (CoAP)",
draft-ietf-core-coap-08 (work in progress), October 2011.
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC 2119, March 1997.
Fossati Expires October 10, 2012 [Page 5]
Internet-Draft Multipart Media Type Encoding for CoAP April 2012
Author's Address
Thomas Fossati
KoanLogic
Via di Sabbiuno, 11/5
Bologna 40100
Italy
Email: tho@koanlogic.com
Fossati Expires October 10, 2012 [Page 6]