Nimble out-of-band authentication for EAP (EAP-NOOB)
draft-aura-eap-noob-08
| Document | Type |
Replaced Internet-Draft
(emu WG)
Expired & archived
|
|
|---|---|---|---|
| Authors | Tuomas Aura , Mohit Sethi | ||
| Last updated | 2020-04-18 (Latest revision 2020-03-09) | ||
| Replaced by | draft-ietf-emu-eap-noob | ||
| RFC stream | Internet Engineering Task Force (IETF) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Additional resources | Mailing list discussion | ||
| Stream | WG state | Candidate for WG Adoption | |
| Document shepherd | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-emu-eap-noob | |
| Consensus boilerplate | Unknown | ||
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Extensible Authentication Protocol (EAP) provides support for multiple authentication methods. This document defines the EAP-NOOB authentication method for nimble out-of-band (OOB) authentication and key derivation. The EAP method is intended for bootstrapping all kinds of Internet-of-Things (IoT) devices that have no pre-configured authentication credentials. The method makes use of a user-assisted one-directional OOB message between the peer device and authentication server to authenticate the in-band key exchange. The device must have an input or output interface, such as a display, microphone, speakers or blinking light, which can send or receive dynamically generated messages of tens of bytes in length.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)