DTNMA Asynchronous Management Protocol (AMP)
draft-birrane-dtn-amp-09
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Edward J. Birrane , Brian Sipos | ||
| Last updated | 2024-07-05 | ||
| Replaced by | draft-ietf-dtn-amp | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Associated None milestone |
|
||
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-dtn-amp | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document defines a messaging protocol for the Delay-Tolerant Networking (DTN) Management Architecture (DTNMA) Asynchronous Management Model (AMM) and a transport mapping for exchanging those messages over a network. This Asynchronous Management Protocol (AMP) does not require transport-layer sessions, operates over unidirectional links, and seeks to reduce the energy and compute power necessary for performing network management of resource constrained devices and over challenged networks.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)