Skip to main content

Slipmux: Using an UART interface for diagnostics, configuration, and packet transfer
draft-bormann-t2trg-slipmux-03

Document Type Expired Internet-Draft (individual)
Expired & archived
Authors Carsten Bormann , Tobias Kaupat
Last updated 2020-05-07 (Latest revision 2019-11-04)
RFC stream (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

Many research and maker platforms for Internet of Things experimentation offer a serial interface. This is often used for programming, diagnostic output, as well as a crude command interface ("AT interface"). Alternatively, it is often used with SLIP (RFC1055) to transfer IP packets only. The present report describes how to use a single serial interface for diagnostics, configuration commands and state readback, as well as packet transfer.

Authors

Carsten Bormann
Tobias Kaupat

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)