Delivery Rate Estimation
draft-cheng-iccrg-delivery-rate-estimation-02
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Yuchung Cheng , Neal Cardwell , Soheil Hassas Yeganeh , Van Jacobson | ||
| Last updated | 2022-09-08 (Latest revision 2022-03-07) | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes a generic algorithm for a transport protocol sender to estimate the current delivery rate of its data. At a high level, the algorithm estimates the rate at which the network delivered the most recent flight of outbound data packets for a single flow. In addition, it tracks whether the rate sample was application-limited, meaning the transmission rate was limited by the sending application rather than the congestion control algorithm. This algorithm can be implemented in any transport protocol that supports packet-delivery acknowledgment (thus far, open source implementations are available for TCP [RFC793] and QUIC [RFC9000]).
Authors
Yuchung Cheng
Neal Cardwell
Soheil Hassas Yeganeh
Van Jacobson
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)