Generalized SRv6 Network Programming for SRv6 Compression
draft-cl-spring-generalized-srv6-for-cmpr-07
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Weiqiang Cheng , Zhenbin Li , Cheng Li , Francois Clad , Aihua Liu , Chongfeng Xie , Yisong Liu , Shay Zadok | ||
| Last updated | 2023-11-06 (Latest revision 2023-05-04) | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document proposes Generalized Segment Routing over IPv6 (G-SRv6) Networking Programming for SRv6 compression. G-SRv6 can reduce the overhead of SRv6 by encoding the Generalized SIDs(G-SID) in SID list, and it also supports to program SRv6 SIDs and G-SIDs in a single SRH to support incremental deployment and smooth upgrade. G-SRv6 is fully compatible with SRv6 with no modification of SRH, no new address consumption, no new route creation, and even no modification of control plane. G-SRv6 for Compression is designed based on the Compressed SRv6 Segment List Encoding in SRH [I-D.ietf-spring-srv6-srh-compression] framework.
Authors
Weiqiang Cheng
Zhenbin Li
Cheng Li
Francois Clad
Aihua Liu
Chongfeng Xie
Yisong Liu
Shay Zadok
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)