Using NETCONF over QUIC connection
draft-dai-quic-netconf-03
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Jinyou Dai , Xueshun Wang , Yang Kou , Lifen Zhou | ||
Last updated | 2020-10-26 | ||
Replaced by | draft-dai-netconf-quic-netconf-over-quic | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-dai-netconf-quic-netconf-over-quic | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The Network Configuration Protocol (NETCONF) provides mechanisms to install, manipulate, and delete the configuration of network devices. At present, almost all implementations of NETCONF are based on TCP based protocol. QUIC, a new UDP-based transport protocol, can facilitate to improve the transportation performance, information security and resource utility when being used as an infrastructure layer of NETCONF. This document describes how to use the QUIC protocol as the transport protocol of NETCONF(It is so called NETCONFoQUIC).
Authors
Jinyou Dai
Xueshun Wang
Yang Kou
Lifen Zhou
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)