Skip to main content

Adding a Flexible GetSize RPC Variant to the AFS-3 Volume Service
draft-deason-afs3-getsizev2-03

Document Type Expired Internet-Draft (individual)
Expired & archived
Author Andrew Deason
Last updated 2011-03-30
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document describes an additional Rx remote procedure call that may be used to obtain the size of an AFS-3 volume dump from an AFS-3 Volume Service. While an RPC already exists for this purpose (AFSVolGetSize), this document proposes a more flexible mechanism that is able to more accurately determine the size of a volume dump in a greater number of cases. Internet Draft Comments Comments regarding this draft are solicited. Please include the AFS-3 protocol standardization mailing list (afs3-standardization@openafs.org) as a recipient of any comments.

Authors

Andrew Deason

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)