Simple Two-Way Active Measurement Protocol (STAMP) Extensions for Reflecting STAMP Packet Headers
draft-gandhi-ippm-stamp-ext-hdr-00
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Rakesh Gandhi , Tianran Zhou | ||
| Last updated | 2024-02-06 | ||
| Replaces | draft-gandhi-ippm-stamp-ioam | ||
| Replaced by | draft-ietf-ippm-stamp-ext-hdr | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-ippm-stamp-ext-hdr | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Simple Two-Way Active Measurement Protocol (STAMP) defined in RFC 8762 and its optional extensions defined in RFC 8972 can be used for Edge-To-Edge (E2E) active measurement. In Situ Operations, Administration, and Maintenance (IOAM) data fields defined in RFC 9197 can be used for recording and collecting Hop-By-Hop (HBH) and E2E operational and telemetry information. This document extends STAMP to reflect any IPv6 options and MPLS Network Action Sub-Stacks for hop-by-hop and edge-to-edge active measurements, including IOAM data fields.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)