Performance Measurement Using Simple TWAMP (STAMP) for Segment Routing Networks
draft-gandhi-spring-stamp-srpm-07
Document | Type |
Replaced Internet-Draft
(spring WG)
Expired & archived
|
|
---|---|---|---|
Authors | Rakesh Gandhi , Clarence Filsfils , Daniel Voyer , Mach Chen , Bart Janssens , Richard "Footer" Foote | ||
Last updated | 2021-07-06 | ||
Replaces | draft-gandhi-spring-rfc6374-srpm-udp, draft-gandhi-spring-twamp-srpm | ||
Replaced by | draft-ietf-spring-stamp-srpm | ||
RFC stream | Internet Engineering Task Force (IETF) | ||
Intended RFC status | (None) | ||
Formats | |||
Additional resources | Mailing list discussion | ||
Stream | WG state | Waiting for WG Chair Go-Ahead | |
Document shepherd | (None) | ||
IESG | IESG state | Replaced by draft-ietf-spring-stamp-srpm | |
Consensus boilerplate | Unknown | ||
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Segment Routing (SR) leverages the source routing paradigm. SR is applicable to both Multiprotocol Label Switching (SR-MPLS) and IPv6 (SRv6) data planes. This document describes procedures for Performance Measurement in SR networks using the mechanisms defined in RFC 8762 (Simple Two-Way Active Measurement Protocol (STAMP)) and its optional extensions defined in RFC 8972 and further augmented in draft-ietf-ippm-stamp-srpm. The procedure described is applicable to SR-MPLS and SRv6 data planes and is used for both links and end-to- end SR paths including SR Policies.
Authors
Rakesh Gandhi
Clarence Filsfils
Daniel Voyer
Mach Chen
Bart Janssens
Richard "Footer" Foote
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)