BIER Ping and Trace
draft-kumarzheng-bier-ping-03
Document | Type |
Replaced Internet-Draft
(candidate for bier WG)
Expired & archived
|
|
---|---|---|---|
Authors | Nagendra Kumar Nainar , Carlos Pignataro , Nobo Akiya , Lianshu Zheng , Mach Chen , Greg Mirsky | ||
Last updated | 2016-07-05 | ||
Replaced by | draft-ietf-bier-ping | ||
RFC stream | Internet Engineering Task Force (IETF) | ||
Intended RFC status | (None) | ||
Formats | |||
Additional resources | Mailing list discussion | ||
Stream | WG state | Call For Adoption By WG Issued | |
Document shepherd | (None) | ||
IESG | IESG state | Replaced by draft-ietf-bier-ping | |
Consensus boilerplate | Unknown | ||
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Bit Index Explicit Replication (BIER) is an architecture that provides optimal multicast forwarding through a "BIER domain" without requiring intermediate routers to maintain any multicast related per- flow state. BIER also does not require any explicit tree-building protocol for its operation. A multicast data packet enters a BIER domain at a "Bit-Forwarding Ingress Router" (BFIR), and leaves the BIER domain at one or more "Bit-Forwarding Egress Routers" (BFERs). The BFIR router adds a BIER header to the packet. The BIER header contains a bit-string in which each bit represents exactly one BFER to forward the packet to. The set of BFERs to which the multicast packet needs to be forwarded is expressed by setting the bits that correspond to those routers in the BIER header. This document describes the mechanism and basic BIER OAM packet format that can be used to perform failure detection and isolation on BIER data plane.
Authors
Nagendra Kumar Nainar
Carlos Pignataro
Nobo Akiya
Lianshu Zheng
Mach Chen
Greg Mirsky
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)