802.1ah Ethernet Pseudowire
draft-martini-pwe3-802.1ah-pw-03
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Luca Martini , Ali Sajassi | ||
| Last updated | 2008-07-25 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
An Ethernet Pseudowire (PW) is used to carry Ethernet/802.1ah frames over an MPLS network. This enables service providers to offer "emulated" Ethernet services over existing MPLS networks. This document specifies the encapsulation of 802.1ah Ethernet Frames within a pseudo wire. It also specifies the procedures for using a PW to provide a "point-to-point Ethernet" service.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)