UDP Checksum Trailer in OWAMP and TWAMP
draft-mizrahi-owamp-twamp-checksum-trailer-01
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Tal Mizrahi | ||
| Last updated | 2014-01-14 (Latest revision 2013-10-08) | ||
| Replaced by | draft-mizrahi-ippm-checksum-trailer | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-mizrahi-ippm-checksum-trailer | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The One-Way Active Measurement Protocol (OWAMP) and the Two-Way Active Measurement Protocol (TWAMP) are used for performance monitoring in IP networks. Delay measurement is performed in these protocols by using timestamped test packets. Some implementations use hardware-based timestamping engines that integrate the accurate transmission timestamp into every outgoing OWAMP/TWAMP test packet during transmission. Since these packets are transported over UDP, the UDP checksum field is then updated to reflect this modification. This document proposes to use the last 2 octets of every test packet as a Checksum Trailer, allowing timestamping engines to reflect the checksum modification in the last 2 octets rather than in the UDP checksum field. The behavior defined in this document is completely interoperable with existing OWAMP/TWAMP implementations.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)