A Mechanism for Available Capacity Estimation
draft-pskim-ippm-capaest-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Pyung Soo Kim , Youn-Hee Han | ||
| Last updated | 2010-02-28 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
In this draft, a mechanism for available capacity estimation of an end-to-end path is proposed to improve the estimation accuracy compared with the existing IGI(Initial Gap Increasing)/PTR(Packet Transmission Rate) mechanism. The proposed mechanism defines three cases of the difference between the average output gap and the input gap, and then reflects fully them, while the existing mechanism reflected only two cases. Since three cases are handled respectively by appropriate corresponding manners, the proposed mechanism can be expected to reduce the detection error for the turning point. Therefore, the end-to-end available capacity can be estimated more accurate than the existing mechanism.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)